Please can someone advise how I reset a samsung M3320nd after paper roller end of life warning tray
Type: Posts; User: newdente.gianluca
Please can someone advise how I reset a samsung M3320nd after paper roller end of life warning tray
I can't find the code for this bushing, does anyone know if it's possible to buy it?
I sent an attached photo of the bushing in case anyone has the same problem
it's a machine with which I have no experience, I think there's no harm in asking since the customer is far from the office and I didn't want to go there totally unprepared
Good morning everyone, I have a xerox machine in repair but I don't have much experience with this brand, the machine is a versalink c405, the colors print correctly but the black doesn't, it's...
not yet, I have to go to the customer, thanks, I will check as you suggested
Good morning, I have this kyocera ecosys p7240 printer under repair, it makes a gear noise a few times, and when it makes the noise the print comes out defective, has this happened to anyone?...
Hello, I have this machine in service, it has a defect that I can't understand, when I take the paper the sheet is taken but then as if it stops for a moment and then it is taken but due to a jam...
life count 165895, pick up rollers changed but problem persist, total jam 0511=147
Hello, I have this machine that causes jamming problems jam 0511, I find a sheet stuck in the fixing unit and a sheet immediately after the paper pick-up (the paper pick-up takes place), if I take...
Good evening, does anyone know the motor code part of this?
3M Service Vacuum
Hi, there is a way to let recognize non oem toner correctly ? i can't see toner level, i send attachment to explain.
56635
I think the problem is this part
Good evening, I have this aforementioned machine with the problem that on the upper side it prints well on the lower side
instead the print comes out lighter, with all the colours, has anyone ever...
Hello, I have this copier that makes a clear line on the printout. I am sending a photo as an attachment, it could be the charging roller? i dont have much experience on this model. thank you so...
Ok, but i have the problem even printing from computer, and every time i have a different result, maby a registration clutch defect?
Hello, I wanted to ask if it ever happened to anyone on this machine that the prints are not aligned, on the left side of the page the start of the print is never in the same place I send an...
Genuine toner
drum refresh, dv refresh, laser scanner clean,color registration, tone curve adjustment. ac calibration.
hello, I have problem with this machine, the problem is both in copy and in print, the machine has 75,500 copies and 3 and a half years, can someone help me to understand the problem?
Yes the paper reach the registration roller
firmware upgraded: all right, it's booting fine. thank you
hi i have this machine with j0105 problem, can anyone help?
i can ear the pressure releaser motor of the fuser unit always spinning, does not stop.
ok, sorry, i have modified
Hi good evening, I have the copier that freezes in this state, can someone help me?(i can not enter service mode