Hi,
alternatively you could remove the rear panel and use the tool which is screwed to the device around the black motor area :cool:
Type: Posts; User: Iradfo01
Hi,
alternatively you could remove the rear panel and use the tool which is screwed to the device around the black motor area :cool:
Hi, stick to the basics, attached is the flow chart for the control panel green led's
basically if its flashing its possibly main controller if its not its possibly power
Hi
iR adv 20/22 Drum replacement
When replacing any drums, always perform the T1-UP reset action which helps prevent the primary transfer voltages from continually increasing.
Prior to any new...
Hi,
the latest version for the iR-ADV 6500 Series is (CONT-PF 03.11) MN-CONT Ver.62.21
Released 03/12/2020
its an old device, so fault finding from the manual would suggest you Check connection with DDI-S cable(RCON).
Replace the main controller PCB ,
for a 3245 would be FM4-1248-000
I would power off, insert usb stick, power on holding 2+8.
then choose overwrite all and let it do its thing. :D
Not sure if this will help or not , see attached
error code relative to the clogging of toner inside the waste toner auger tube. If this code is present and the toner auger tube is clear and MS5 is operating properly, check to see if the exhaust...
Hi,
Canon recommend the following actions for MFD’s that support only SMB v1 such as iRADV C52XX:
Request the customer to use either WebDav or FTP instead of SMB v1 for scan to folder...
not had one for a while, you can reinsert the wires into the plug if you're lucky
if not its an easy replacement
FM4-6571-010
:)
No Problem
FB5-3625-000 X6 Sep claw
Hi,
haven't found a kit available i use canon parts below.
FC5-2286 WEB
FL3-3602 UFR
FM4-3158 LFR UNIT (INC BEARINGS)
FC9-8067 ...
you can also ensure the drum warning is set to OFF
copier>option>user>P-CRG-LF to 0
set the parameters for D-DLV-CL and D-DLV-K TO 140
hi,
Hope it helps
press home key,
press the space between home and energy saver
press the space between home and stop
press the volume key on the side
press the stop key
should be good to...
agree with above,
there a 4 wheels and 4 encoder sensors on the main drive box
give them all a good clean, sensors are easy, wheel can be a fiddle to get off.
Wheel FL3-4135-000
encoder...
as said no easy fix for this error.
ensure device is level, you can try and adjust the motor on the ITB,
there is a MOD kit which has worked as well FM4-8409-000
The only one that makes any sense would be E002,
E002 0000 Title Fixing Assembly temperature rise error
Description 1. The Main Thermistor detected a temperature lower than 115 deg C
for 400...
E100-0001
BD signal issue ;)
could be the laser shutter/laser assy/laser driver pcb
if its not the laser shutter its time to get your meter out and trace 5v etc on the boards
hope that helps
Hi,
Re fitting a 52xx to a 50xx, different connectors and different part numbers,
Hi All,
sorry to jump on this thread,
I have the same on an ir400 it started with E602 then after changing the HDD and flash rom it is now E614-4000
I have changed main cont, HDD and Flash...