Thank you.
Type: Posts; User: Wbankard
Thank you.
Over 40 yrs a tech, read my other posts.... I do not know much about this Ricoh... Certified HP tech [ printers and computers ], IBM, Levono, Sharp (old stuff), Mita Copiers, Early Ricoh, Compaq,...
How do I get into service mode and check the PM statis?
RICOH MC305SPF Black toner sensor exceeds specified value. Can that be caused by the end user twisting the cartridge? Best way of correcting this issue ? a sky copy total black? Several dark prints?
Thank you all for your help. The problem was the detente in the housing stopping the cartridge from touching the sensor board.
I am not familiar with the software upgrades. I'm working on this printer for a friend, I'm HP certified not Recoh
Thank you for your help. I ordered the housing assembly. Get back after I put it in.
Understand that has been replaced and the original was not bad
OK , I've replaced the toner sensor PCB and cleaned out the copier, Installed OEM toner but it still states reseat the toner.. Problem >> the housing the cartridge goes into at the end, that opens...
After 3 3rd party toners that failed we assume that it's the wrong chip in the cartrage
Found the problem --- I'm embarrassed --- put connectors in wrong socket. poor lighting.(excuse) lucky that it did not short out the board.
Checked connector CN559, no bent pins. HVPS was not removed to install the toner pcb . The other large components that were removed: the ARDF, fax pcb, BICU, network assembly and the BICU housing.
...
Thank you all very much, I'll give these a shot and let you know.
I have checked the fuser assembly several times, and that was not removed or fulled with. The Fuser wiring goes up the front and then towards the back to the controller but I have no clue which...
After reassemble the system states to close the fuser door. What where and how ? All connectors seem to be in their place on the main board. The fuser was not touched and was working before the...
I was wondering if we were talking about the same thing. The board I removed was located across all four toner supply pumps. Each one has a pin guide and three ribbon contacts for each pump area. A...
Interesting the part Number on the board is D1175161A, update / mod ?
Toner not set!!!
I can understand the bent pins on the board, DUMB WAY TO MAKE CONTACT, but how do I get to the pumps to fix them? got a book on order. EU used third party toner not OEM and then...