Nobody knows?
Type: Posts; User: ondemandprint
Can I use 105K22911 instead of 105K20932 on dc240? Or it's dc242/252 unit only?
Hello!
There are some questions:
1) What's difference between Power Unit (XC) and Power Unit (XE)? Voltage?
2) Can I use 105K22921 or 105K22911 Power Unit (AC Power Supply + LVPS) instead of...
Can you send me all this files?
Can you help me with both?
PWS 11.3
WCPP 040.033.50363
Can you help with this "full software"?
I've both and service documentation. What is "full software version"? And can you help to obtain it?
You're right!
Can I use such firmware? WC7655/7665/7675 SPAR software version 040.033.53375 and instructions - WorkCentre 7655/7665/7675 - Xerox
Or there is a special AltBoot FULL firmware as on...
Hello.
I'm searching for early AltBoot firmware. My 7665 stuck on Scanner Engine update after electric disaster at our district.
I recovered it some times for last years but it stucks at 0% this...
There is only CF-card in FAX module. I can't see any other type of cards on the board.
Xerox 5745 stucks while firmware update. It's always "Print / Copy Engine" ~25%. Other blocks are successful. As a result printer boots till greenish xerox background (without showing actual 5745...
For now there is only background on the second side of duplex printing. As I think it's because of page goes via fuser unit. Bad transfer on hot dried paper? External humidity is 35-50%.
Simplex...
Putting 1 or 2 wraps on the stopper rollers solved beating trouble.
Additional question about stopper plates which interacts with DEVELOPING STOPPER ROLLER. Are they tightened or loosened?
On my...
It's not silly at all, thank you. I reset and performed installation procedure with adjustments.
Beating is the main trouble as I think. Something wrong in Cleaning Unit - Drum - Developing Unit...
Where are they? Do you mean developing unit stopper rollers and stopper plates interactions?
Hello.
There are toner tracks with circumference of drum (leftward on the picture, operator's edge at the machine) at the same places mostly. Also there is some background. The page is A3. Please,...
Problem is solved fully.
There was Separation Plate (in the Fixing Film Unit) with debris of hardened toner on it.
Hello.
There is a problem with dirty strikes. On the every printjob 1st page back side only. About 3-4 very thin intermittent lines along paper path.
There are no or minimal strikes on other...
Can you make an image - as seen on printer's connector? Is it necessary NVM 12-001 = 100 in this case?
Hello.
How to use these machines without any finisher? I tried NVM 12-001 = 100 and remove finisher, but it does not work. Printer requires finisher at startup and doesn't print.
Hello.
I bought Xerox 5665 in used condition. On every startup there is job appears from nowhere and prints. It's always the same part of something document. It's not Startup banner and so on. It...
Hello!
There is a strange trouble every 3-4 master making. In this case RP is doing all missions in the right order but drum's clamp plate stays closed while projected master loading. As a result...
Hello.
Strange issue with test 101: Ink supply operation.
3770 (as 600dpi) has addition in this test:
"Until the ink sensor gets ON, the main motor and the ink motor are held ON.Ink sensor ON ⇒...