I am not getting any magenta at all and i know to push in the gray post for the mag roller, no codes. Replaced mag-developer unit with new, made calibrations still no magenta. Ran sim 30 with no...
Type: Posts; User: T911
I am not getting any magenta at all and i know to push in the gray post for the mag roller, no codes. Replaced mag-developer unit with new, made calibrations still no magenta. Ran sim 30 with no...
That was a typo.
Actually the message is pf not np and it's a map 3500
what is the difference between fm4-7712 and fm4-7713 upper fuser guide.
Can't find this error anywhere, any help appreciated. Thanks
No idea wasn't at the location when it happened. No mention of power failure
Great thanks guys. I did press that button in the waste arra and it worked.
I can't get the f----n front door open to access the fuser, transfer and reg area. Is there a secret to this or am i missing something. Never had this problem b4. How is the client supposed to take...
So I think the only thing I will need to do is 2801 and turn off 2804 is that correct. If I'm missing anything let me know.
Thank you so much
I believe this a MP2550. Can I put in a Type 1027 PCU and calibrate on this one. thanks
Had a e025-0300 error. My tech went back to replace the black toner supply motor at the back inner frame of the machine. Now he has the cq issue attached please review and if anyone has experienced...
Great thanks
How do i calibrate the developer and reset the drum count after rebuilding it or does the fuse reset the drum. I also will need the service mode procedure to calibrate dev atdc. Thanks
Thank you so much
is there a fuser reset procedure for this one or when a new is replaced is there a fuse that pops on the unit to reset fuser unit life.
Thanks
i'm not a toshiba guy but i need to replace the developer unit and drum unit on this one and i do not know how to get into service mode to do calibrations on the units. help much appreciated.
Having quality issues. I replaced all drums and developer units, tranfer unit and secondary roller, high voltage pwb, feed image pwb, drum dev relay bd and still the same after speaking with kyocera...
It was fw update
this one will not but up and tells you to shut down. I turn the switch off but it doesn't want to shut off, i have to pull the plug to try the resart. it is stuck on the xerox screen. im going to...
this one has a BFO-1 finisher on it but i need to swap. can i put a 2AH finisher on it with the same bridge.
Thanks
Is this model supported by xerox anymore. Is it discontinued? Thx
Okay thanks anyway
Murv,
I don't have another b8045 to re-image the 4gb sdhc with. do you have one that you can share with me. thanks
anything stored on the sd or just put in a blank one, fw reinstall? Does it need to be formatted before install? X not my cup of tee. Kyo guy
I have a b8045 with the same problem listed above. My code on the LED Display is 5. Help Appreciated. Thanks