Search:

I believe I figured it out. It seems like it jumped a cog on the gear that is for the paper size sensor assembly as it was showing 12 x 18 when I had 11 x 17 in it. I was able to get it realigned so...

No kidding I know that. The problem is that it is looking for the size that is already there.

I am getting a error in the MP tray I will scan a letter size sheet it will print a few copies then it says to add correct paper even though the letter size is in there already it does it from scan...

After a good look around it seems that the master loading sheet was bent down and was touching the drum making the mark

I have a image problem (see pic below) riso rp3105 It is machine related meaning if I move the drum to another riso it goes away but any drum in this riso it happens to I replaced the pressure...

Of course I tried a different drum and I retimed the machine it makes the master but cuts it short because it doesn't get into the clamp to the only error codes are A16 525 and a34-213 Again the clam...

I have a RZ220 that no matter what will not apply the master to the drum. I swapped out the main board and master making unit still no joy. I have pulled the front cover and it removes the master...

I fried the inverter in the 3105 and am having difficulty finding one. I had the lamps on and touched it lets just say it was a shocking experience. The lamp went out and they wont come back on.

Can I put a rp3505 scanner on a rp 3105 I know its a higher dpi scanner but has anyone done this?

I have a Copystar 6551ci scanner that keeps throwing a 3300 code the led lights light up but it wont go away is there a way to disable the scanner all together until I can get the boards in?

I looked into u068 and adjusted it it was 0 but i had to change it to 13 and then had to adjust u071 to remove a black line

No it just happened out of the blue 1 min it worked fine the next scan job it was screwed up

I have a 6551ci copier and the scanned image in the document feeder is bad see attached photo. if I print its fine and if I place it on the stage glass and make the copy its fine just thru the...

I have a Rp 3700 that only burns half the image on the master the scanner is going all the way across the image I replaced the board that the TPH plugs into same issue. Anyone else had this problem?...

Ok I figured it out I had the stage glass off also and apparently it was millimeters out of position so the sensor wasn't getting the correct amount of light. WTF

I have a 6551ci I had to remove the scanner to get at a part now the error c3300 comes up all the lamps work in test mode any suggestions on what it might be?

No when in maintenance mode I run the motor and stick a piece of paper in and it immediately stops.

Replaced board new firmware and still stalls front pwb?

Yes I replaced the engine board and need to update the firmware

Can somebody send me the Firmware file for the kyocera 6550ci.you can upload it to my google drive I will send you the link in a pm.

Thanks

Now which board engine pwb or front pwb

Nope it stalls when I run Maintenance mode 0030 cw & counter clockwise sometimes it starts and sometimes it doesn't nothing to do with the fuser

I just swapped the whole unit exit from another printer same issue I'm thinking its a board issue.

checked the sensors and narrowed it down to the exit motor I found that the exit unit motor stop when the paper hits it EVEN STARTS AT ALL I replaced the motor same problem it spins until the paper...

Yes replaced them all I even replaced the motor The motor locks up when paper hits it. its a power issue.