I'll give that a shot. Much appreciated!
Type: Posts; User: Techout
I'll give that a shot. Much appreciated!
Hey All,
I have a Xerox DC 252 with error 010-320 (fuser heat error). When following the NVM read/write protocol ( 744-350 write to 0) the device freezes when I select confirm. The control panel...
10-4. Figured out the password the old way. Thanks again all!
Thanks Phil,
I've tried the 9272x2 approach. I've had trouble getting support from Konica Direct in the past. Do you have any recommendations as to how i should go about this?
Best Regards,
...
Thanks Phil,
I've tried the 9272x2 approach. I've had trouble getting support from Konica Direct in the past. Do you have any recommendations as to how i should go about this?
Best Regards,
...
Hello,
I am having trouble acessing Service Mode on a Konica 958. It seams that the gerneric passcode : 9272927292729272 has been reset by a pervious service provider. Is there a way to bypass the...
Much appreciated sir! I'll circle back with results.
Best,
Anthony
I had a corrupt CF card. Power surge flashed the existing CF. I replaced with a CF from another working unit. I'd prefer not to shotgun more than i already have. Trying to identify a procedure for...
I had a corrupt CF card. Power surge flashed the existing CF. I replaced with a CF from another working unit. I'd prefer not to shotgun more than i already have. Trying to identify a procedure for...
Have error code C-C104
Current error code : C-C104
Hello,
I am in need of Bizhub 751 firmware. Any help is greatly appreciated! Email below.
technologyoutfitters@gmail.com
Best Regards,
Techout
Any updates on this one? I am having the same issue. Same error code but jamming just before the decurler @ holepunch position.
Does anyone have schematics for this particular finisher?
Hello All,
I am currently having an issue with the Light Production Finisher on a Xerox DC 252. I am getting a jam @ the Decurler out position error code 012-101. There is no blockage in the paper...