Search:

Hi Everyone!
I have a Kyocera KM-5050 with JAM00 error caused by connecting a DF-720 inner finisher. I've checked all the switches in the drop down tray and have swapped out the inner finisher that...

Hi Smart People! I have a customer who recently moved to a new location and since then, every time he runs prints into the finisher(upper tray) the paper curls downward as it goes into the tray...

Hi People!!! I have a Ricoh c4503 with the newer smart screen device interface control panel. My customer wants to buy the machine, but they want the default screen to be like the older style. What...

Lately I have had a ration of defective drums that within a week or two start leaving a black line(lines) on the prints or sometimes a white line(void) on the prints. So a friend who works for a...

Hi! Got it figured out! I took a laptop into my customer's office and connected it directly to the machine via USB cable/port. It worked fine and apparently there is a glitch in the software. Having...

Hi People! I have a customer with a Kyocera taskalfa 4500i that won't pull paper from the MP(bypass) tray went a print job is sent to the copier. I go to the printer page setup and select the MP tray...

I've got a Richo Aficio 1515f that's making perfectly good copies but the "replace drum " is in the display. I downloaded the service manual but can't seem to locate which SP number resets the drum...

Hi Jeff!
Can you tell me where that connector might be? Does it face outward from the end of the machine? What's it mounted to? If I had another machine,I'd have my answer. I've checked with several...

Hi Guys!
Yes, Jeff, I think your on the right track. The is a Interconnet pcd board located on the top of the service station at the right end if the machine. There are several connectors there,...

Years ago, Mita would keep parts and kits around for about 8 years. I don't know if that is still true since Kyocera took over.

Hi!
Burning question! I had a tech go out and replace the carriage belt. When he was putting everything back together there was a connector coming off the pump motor underneath the ink station. The...

Hi!
I have seen this problem on many of these machines.The other reply was right about changing the dev.but make sure the tranfer roller is clean as well as the bushiings it rides on. Sometimes just...

Okay, put on your thinking caps! Here's one that's got me going in circles. The above named color copier/printer has fault codes(3.316.00, as an example) which will not clear. I have tried asking...

Hi!
You need to change the developer and set it up fpr new developer. After replacing the developer, cheat the front door interlock. Turn off the power. Hold down the print and exposure buttons(not...

Hi nichjar and the rest of you great techs! I figured it out. Apparently this machine has a optional counter available, but way too expensive. But I did find 4 new resettable counters(24v) on Ebay...

Help Guys!
I have a Km-1530 that works fine. Here is my dilema, I have a customer that has a chain of small convenience stores. What the customer wants is to install copiers in the the stores and...

Hey Fellow Techs!
Here's one that's got me stumped! I have a Km-4530 with about 400k copies that leaves the front half of the copy blank. After stopping the copier in the middle of the copy cycle...

Hello Dean, you might try going into the machines service mode. 1087,1087, and push the print button. You'll have a choice of three modes. One will print out all the simulations, the next will print...