Fuser must be replaced new.
There is no fuser reset its built into fuser like a one time fuse.
Fuser/Maintenance End of Life Statement from Laserpros.com below.
Lexmark M5155, M5163, M5170, MS810,...
Type: Posts; User: Crusher
Fuser must be replaced new.
There is no fuser reset its built into fuser like a one time fuse.
Fuser/Maintenance End of Life Statement from Laserpros.com below.
Lexmark M5155, M5163, M5170, MS810,...
This be good one for a sample picture. If dashes you mean like rain dropping all over at random not repeated. It's usually developer and be caused by bad toner or mixing of 2 diffrent toner brands...
The one way bearings, 2 of them on same shaft on feed assembly, run cloth through them, I use bit of alcohol on them and rotate on cloth. You'll see the dirt come off the one way bearings. If you...
Repkave Fuser and / or Kyocera P# 302RV94020 Fuser Drive Plate. Comes out bottom right if memory serves me, pretty easy.
Symptoms J4211 codes, smearing, intermittent at 1st. I have had to replace...
C6220 I fixed by removing paper between the fuser and induction coil right behind fusrr. Take a minute to pull it. Good luck.
I have similar situation going on. No errors, just stops 12 to 24" on scan and saves file. I am aiming to replace paper sensors in scanner there are 4 of them. I had couple techs says flakey hdd can...
Had hinge on backside cause lift issue intermittently. Spring attached can be hard to see, but you can move it more than it should. 9005 error from no paper feed, lift not raising up far enough, feed...
WSD has been causing water mark dialog recently. I disable it on Kyocera copiers and printers. Windows updates have in past completely deleted driver, turns on wsd port and installs Microsoft ipp...
Firmware is listed. Then do order developer refresh, calibration and then toner curve. Out of service manual. Hope it helps. You may have to do developer refresh process a few times, not sure why it...
Open from the cover. See a lock and unlock symbol. It needs to be in locked position.
Goto Adjust and Maintenance and hit reset. Only shows up when Maintenance message happens.
Its a network function.
Goto Administrator/ Network settings/ TCP 4/
It's under auto obtain ip function, with DHCP.
Turn it off if not needed.
Lol, over confidence can be a trap. I ran into this when I didn't screw the Flatbed scanner cable on right side of machine in after changing out a tray 1 paper size sensor.
Colors are Cloudy too, replace image units, can sometime help with Color shift otherwise, under Untility Key, then Adminstrator mode goto expert mode and fix registration manually. Procedure is in...