Absolute legend ! I should have looked here before ripping the finisher apart. 😂
Type: Posts; User: drew007
Absolute legend ! I should have looked here before ripping the finisher apart. 😂
Hi. 8002 won't let me in admin mode/sm/factory mode. can't open extended features on panel. can still see wim.
tried the factory reset (./ + #). it just bleeps once and doesn't reboot.
Any ideas ?
MPC5504ex. This helped. Many thanks. ;)
Hi everyone Drew here.
Just to add to this. I've found that users aren't prepping the toner before fitting it.
Please direct users to gently shake the toner cartridge while it's still in...
Hi guys.
Long time member... Not a good poster. LOL
I have the same 46.23.3C error code after fitting an ITB kit.
So, I removed and refitted the new ITB. Making sure it was pushed in...
I did order some ozone filters for the two devices, a couple of weeks back. Been on holiday since and those calls are gone off my clip so someone must have fitted them and not reset the counters. ...
Hi all
don't normally deal with konica's. but...
I've got 2 c654e's with papercut, which both show a message saying that there's a device error either no paper or a paper jam each time a user...
Hi all
I have come across error codes 63.00.40, 3E, 3C, 42
cyan, magenta, yellow, black.
Toner is compacted in the cartridge and does not refill the toner reservoir. The compaction is likely...
I'm experiencing the same thing. 1/4 of the progress bar only.
Have tried 2+8 on boot but does not go into download mode.
I can see the scanner lamp take it's reference reading and hear some...
Hi guys.
started with an E020. code. dev unit was packed, so I vacc'd out the excess toner. noticed that someone had mucked up the connector to S25 (td sensor on dev unit). Anyway I've replaced...
I've just changed the main control board on an mpc5503 due to intermittent sc672 errors.
waiting to see how it goes.
the rollers aren't turning. so the paper isn't hitting the sensor.
can't activate the rollers in output check.
can see sensor on input check.
I can see the sensor change state on input check. I think that I may have a different problem.
Still looking at iob board.
I looked in the SC history. only 1 code. 670 I think. it's a relativity new machine.
I swear I remember someone talking about a similar problem with the xx03 models, but I can't for the life of...
Got called out to an mpc6004ex showing jam in R1-R4 but no paper there.
opened and closed the doors and cleared the jam condition. There was no paper there. Not surprising cos 205 is a delay...
I have this on an mpc5503.
simplex ok but the paper stops at the inverter rollers. the 024 code just means the paper hasn't reached the sensor, which it hasn't, because the inverter rollers...
They should make the copiers voice activated like Alexa. I could have some fun with this.
"Just fuckin work" would start the shutdown sequence.
Startup phrase like "welcome, human slave".
or...
Is there a solution like papercut involved ? prints would go through that for tracking/accounting. That server would need to see the new IP address also.
If you're scewing through adf and not on the glass then adust the adf for scew. Never had to do this myself cos they're usually quite straight. Would be worth cleaning the paper path and feed...