Anyone dealt with feed duplex issues guide plate above 1st. Tray doesn't seem to lower?
Type: Posts; User: davydoodle
Anyone dealt with feed duplex issues guide plate above 1st. Tray doesn't seem to lower?
I have a issue with the machine showing copying off the glass or DF but just idling for 3-5 minutes then pops a 955 code tried FW, controller, memory, HDD, IPU, CCD, SIOB.....prints/Fax in with no...
Was a bad new fuser from a sealed box, lamps tested ok...QC strikes again
Any direction same jams, swapped sensors patches clean, changed ow bearings that drive feed in...
Looks all direct motor driven....
The first one make it out fully ok...
No creases...
Jams after the second original; did sensors, ow bearings on the back?
Brand new out of the box, lamps good, book says try power supply
Yep did that, failed...
Swapped fuser on this little jem of engineering, ng. power supply maybe??
Yep, it was the waste bottle...
Heat warped....
Turned out it had to be merged with the existing PS card...
Turned out to be the fuser exit guide
Any body seem this, with the pdcu out of the machine?
Only on single side face down, guides smooth and straight, sensors ok?
Sent from my SM-G900R4 using Tapatalk