Search:

Hi all,

I have this Xerox workcentre 7242, which was setting for a few weeks, then moved to another location, not sure if it was working fine before moved, than I am getting these prints/copies ,...

44285

here is the error message

I replaced the fiery, then this SW upgrade happened automatically once I switched on the machine, I still have same problem with the scan, same error message

44284

Hey guys,

I got this error whenever I do network scan "Job deleted due to system image error" its a Xerox Workcentre 7655, I did the security image overwrite on demand, full overwrite , and also...

Hi all,

I have Xerox Workcentre 7655 , WC7655, I get the error 'replace fuser' , I tried putting fusers from other working machine, still same, I just today put a brand new fuser, working put the...

these are the error messages I am getting now, any idea how to rest the machine?

so replaced the HDD , used a HDD from another same model printer, the printer is booting up , but gives me the error message "device power on failed...ets . reset device ..etc" see attached picture....

any special treatments, does the USB flash has to be formatted FAT? does the HDD has to be formatted before installed?

Replaced the HDD with a brand new one, used the USB with altboot, and the firmware in it, all case sensitive, followed the manual exactly , still printer does the same

I also tried the altboot, it does not seem to reach to the point where it reads from the USB that has the altboot. I read the manual can't see where should the HDD should be, is it hidden somewhere ?

thx a million, where would the HDD be? I opened it and found the board and all but could not find the HDD,

and could be the problem is the SD card corrupted ?

So when I power the machine, i get that screen attached with nothing on it for about 10 minutes with the green "interrupt" button flashing " then the machine reboot then again goes into that screen...

looks like something wrong with the finisher yes, another finisher is working with the same printer.

What went bad with the finisher ? any idea?

current errors in the attached pics,

also previous ones

So I replaced the transfer belt assembly unit with another working printer, so now I get another error "The finisher is not available, contact system administrator"

I recall that the printer...

Yes I see that error 42.326.00
and also 20.331.00

I have a Xerox Workcentre 7655 who stopped working, and shows error "System fault, contact administrator" , no fault numbers or anything else

the problem started a couple of weeks ago, rebooting...

Thx everyone, yes that was the only way for me to get it working, not the best, but ok.

aspmx.l.google.com



Port 25
TLS not required
Dynamic IPs allowed
Mail can only be sent to Gmail or...

Thx guys, appreciate your great help , just done with it, had to take it a part and give it a good detailed cleaning and replaced the Magenta developer tank , it was painful & time consuming process,...

it does not show tls nor ssl anywhere on the printer setting, it shows on APOP authentication only, so I am guessing it has no SSL nor TLS,

Any email service provider that can accommodate that,...

Hi all,

I have these faded lines only on magenta on Xerox Phaser 7500DN, any one had this before
?

Pls see attached images, I marked the line in black on the second pic

authentication ON use full gmail address also password , Yes did that
Sender must be the same , sorry what do you mean, its the same full address and password everywhere it requires email and...

Yes I did set the gmail to accept less secure apps.

and I tried these ports, as on gmail guide


Less secure app accessYour account is vulnerable because you allow apps and devices that use...

here how about this, tried my best and sorry for the previous.

I also tried these ports, as per gmail, I feel its something with authentication -

Step 2: Change SMTP & other settings in your...

and here are the rest of all settings