Had the same problem on 3 B&W fusers M3050, H5-01 with no other jams. I replaced POD1 sensor and haven't heard from any of them since.
Type: Posts; User: miller01123@gmail.com
Had the same problem on 3 B&W fusers M3050, H5-01 with no other jams. I replaced POD1 sensor and haven't heard from any of them since.
Get a darker blue pencil. Most copiers have a hard time seeing light blue pencil, IME.Especially a cheap one.
I've found that the center pusher on the assist unit locks up on the guide shaft and causes the unit to go out of timing. This starts to happen after 40 to 50 thousand copies. The only solution is to...
no way to tell without taking the covers off. the 360fu1 has white wires going to the main connector and the 361fu1 has black wires.
I have no idea but every time I have a strange problem with a sharp I replace the SD card if it has one. 9 times out of 10 that fixes it.
Did you try an SD card?
Did you reset the code in sims after?
Clean and powder (friction reducing powder) the transfer belt cleaning unit side seals. They will make a dog whistle noise if they have toner build up on them. Also the exit unit above the fuser will...
There is a problem with some machines where the seal under the cleaning blade is not attached properly, causing dusting of the charge. this will pull DV.
Also, if it does have a security kit it will say FR11 or FR11U on the ROM on the MFP. You will need the firmware for the security kit. You may have to do an Emergency Update if you can't get into the...
I use dban and use the single pass erase. I believe you need at least a 320 gig hdd
Was it a blank hard drive? If not, you need write 0s to it.
It's a USER password PHIL. Easily found in an internet search. No security breach there. Also changeable by the end user to make the MFP more secure, if so desired by the end user.
On the op-panel of the machine you should see a Settings button. That should get you started. The password should be "admin".
Thank's PHIL! Should have said Printer Settings instead of Copy Function Settings. Edited my previous post.
You could try doing Auto Color Calibration under Settings- System Settings/Printer Settings/Color Adjust or you could try Restore Factory Defaults under System Settings/Storing/Calling of System...
Yes, there are pressure screws. I've had this exact problem because someone didn't realize that they were there.
4700847009
Check the coupler that turns the toner cartridge. I had one that somehow got pushed back and was not touching the cartridge.
Try the clutches on the main drive that lift the T1 rollers.
Did you check to make sure the fuser pressure screws are backed out completely?
Do you have the right model number?
I always suspect the SD card first.
You will have to figure out why the home key is not working.
Clean and powder the felt side seals on the primary transfer belt cleaning unit.