You may want to take a look at the developer mag roller if it is smooth. Remove the developer material and using an abrasive pad, sand paper, or steel wool scuff up the mag roller in the long...
Type: Posts; User: BTech21
You may want to take a look at the developer mag roller if it is smooth. Remove the developer material and using an abrasive pad, sand paper, or steel wool scuff up the mag roller in the long...
If you are still having issue try to set the Ethernet speed setting to a static speed. I have had a few machines that couldn't auto-negotiate speed with the network.
Check your drum drive and make sure that the roll pin didn't shear off.
Which browser are you using? Try putting XXX.XXX.XXX.XXX:8080 in the address bar.
You don't need to turn off network discovery just the "Automatic setup of network connected devices"
We set up a short cut to the file share using the ip address "\\xxx.xxx.xxx.xx\file_share". Of...
Win 10 auto loads the v4 driver if WSD is enabled on the copier. You can disable it in the copier thru the web interface or you can turn off auto discover devices in windows.4290742908
What color is the rear registration pusher? There was a bulletin that said that static discharge from the registration roller to the rear frame would cause your issue. The updated part is black in...
You may want to pull out the laser unit and check for dust inside the unit.
Check the registration and 1st transport sensor flags. The original shinny plastic actuators would wear quickly.
I have seen this issue on that machine. Some times you can disassemble the clutch an clean with alcohol. I would replace the registration clutch.
03-115 should test the RADF motor.
Try, going into 03, then press "start", then "fax" (fax light lit), hold 1. The box G should not be highlighted. If it is there is a switch in the machine that detect the auger lock. Also make...