uploaded the special firmware beginning with GDB to the copier, set bit switch 219's hex code to 04, and entering the file path in ALL CAPS with no backslash resolved my issue.
Type: Posts; User: popup2u
uploaded the special firmware beginning with GDB to the copier, set bit switch 219's hex code to 04, and entering the file path in ALL CAPS with no backslash resolved my issue.
uploading GDB firmware to copier and setting ss 219's hex code to 04 , along with entering in the file path in ALL CAPS with no backslash, resolved my issue. Thank you all for the help with this issue
It was on the right side mainly, on the gears, if you turn the fusing unit on its right side some should fall from out of the unit itself, and in the back corners of where the fusing unit sits, but...
Alright. I ask because I had a fusing unit make a squealing noise similar in the video but when I took it out there was rust colored dust in the corner. Turned out that the bushing had pop out of its...
If you take the fusing unit out do you see any rust like dust in the corners or on the gears?
*^ Blank copies
The copier does not have a paper deck attached and never has and it's giving me blank copies. I do hear tray 1 lift and it sounds like it keeps restarting when beginning to pull paper
I'll be sure to turn it off and the only antivirus is the window's firewall
Yes I am able to open the web interface and do you know which special firmware it is? I could get it and try it tomorrow and which bit switch? I used to always create a new user when setting up scan...
I'm sorry about the improperly labeled title. The machine is an e series machine, has windows 10 home edition (Version 1903),network is a private network and the copier SMB client and server are set...
lol I know the I.P. address is incorrect, I just didn't want to put my laptop's actual I.P. out there but as far as the file path is it correct for the C284e? Should I have it in all caps with no...
Gives message saying " there is an object in the paper deck, remove it to prevent damage" replaced DCON board, performed DCON backup, clear, and restoration ( back up, board replaced, DCON clear, and...
That'll be the next thing I check
I have a laptop with windows 10 Home installed and my scan to folder was working but stopped work. I created a new shared folder and gave the user account read/write capabilities, turned on folder...
I have a laptop with windows 10 Home installed and my scan to folder was working but stopped work. I created a new shared folder and gave the user account read/write capabilities, turned on folder...
replacing the spring and actuator fixed my issues. Thank you all for the advice!
Just checked my actuator and it stuck as soon as I pressed it. I'll replace it and let you all know my results
I'm assuming that is for the registration error?or would that cause both problems
image stabilization, gradation adjustment, transfer belt cleaning and charging CH cleaning, was performed also
I have a 654e that shifts that starts making copies fine and then eventually shifts the image and cuts off the right side of the image; while printing some copies about halfway through images switch...
I have a Canon 4051 with major issues. Most of the time the copier will give you blank copies, even though the CCD scans the image and when it tries to pull from tray 1 the copier says "preparing to...