If the rollers are not making contact with the paper to pull it through, check the solenoid, the door cable/connector or the main board. More likely it's the connector not pushed all the way in.
Type: Posts; User: Mr Magic
If the rollers are not making contact with the paper to pull it through, check the solenoid, the door cable/connector or the main board. More likely it's the connector not pushed all the way in.
Ok. I hear you. Let's take it right back to basics! Try again with a fresh ream of paper, but this time - clean all paper paths sensors and try it from the bypass tray. Someone mentioned checking...
LOL.....Apologies!! Let me go and hang my head in shame in a darkened room! ( I clearly didn't see that!!) Ha ha ha...
Hey buddy,
Look at the Fuser Assy. again.
Hey buddy,
Order:
2 x Reverse Rollers &
1 x Gathering Roller
(whilst replacing the rollers - don't forget to clean the sensors)
All the best
Sounds like the scanner block is out of alignment. Are you able to fit the Scanner Lock - it may just need straightening. Place a A4 sheet of paper on the glass and see if there's a gap. Does it line...
I don't, but check these guys out:
https://www.aliexpress.com/w/wholesale-kip%20parts.html
Sounds that your Freeflow may not be setup correctly! Checkout:
xerox.com/en-us/digital-printing/workflow/freeflow-core
&
YouTube
Is he providing OEMs? or compats?
This night help!
YouTube
Please provide more detail. Does it look like watermarks? Could be condensation! But still, would need to see!
All the best!
Log into the device and check the security settings. Something should jump out at you there. It's much easier to navigate this device via the web than via the Ops Panel..lol
All the best!
These babies dump toner and can give a host of errors. Start on a clean slate and vac-out the machine, making sure the slit glass is clean! Also, make sure the Transfer Roller hasn't popped out -...
I take it the device is a Xerox? Go Xerox site and double-check. Try printing from your laptop. How many PCs are you trying to hook-up?
Sorry, just double-check basic steps. On a different day,...
...also, as soon as you hear it - push the right-hand door and see if it goes!
OK!
Clean the ID Sensors
Let the machine power-up and run the calibration again
Update the FW (remember to print config and demo pages) then compare on completion
Try down-grading the FW!
Be sure to install the Mac version:
imageRUNNER ADVANCE C3325i - Support - Download drivers, software and manuals - Canon UK
Check Drum life & swap Yellow Drum with another colour!
Hey!
I'm a bit late, but have you checked the life of the drums? Are they originals, or compats?
Ok. Thanks for the update. Sometimes, FW can fix these sort of issues.
Nice one for identifying the cause.
:)
Try updating the FW.
Yeah, it's there. Under the '03 series, look for:
Technical Bulletin
In addition to the previous advice, clean the ID sensors (if you haven't done so already), then run colour mismatch, then run the calibration/gradation again.
All the best with that.
Short-term: Get a cloth with some waste toner on it & clean with that! Long-term: - replace the belt!!!!! lol
This is crazy!! We need to isolate this!
Setup SMB on your laptop and test each copier.
Yes the FW is different for the Z model. Send me a direct PM and I'll send it to you. However, you...