Hi,
now i make 3x a Diagnose from the System and get an Error BK-044.
This is the Thick Set Sensor.
If i go to the Sensorcheck it is 1 and if i test it it goes to 0.
Is that correct?
...
Type: Posts; User: Bettachild
Hi,
now i make 3x a Diagnose from the System and get an Error BK-044.
This is the Thick Set Sensor.
If i go to the Sensorcheck it is 1 and if i test it it goes to 0.
Is that correct?
...
Hi,
The Counter:
Staple: 21682
Fold: 37320
Knife: 31855
At the Moment i would fold 3 Paper 100g.
The Staple is on the correkt Place on the Paper. But the Fold is aktually 2 cm on the false...
Hello,
on germany it is verry important to find an Technican.
For an other Plockmatic i had an PCB Error. Only the way to me and install the Platine they would 2.300 Euro + the Platine.
...
Hello, I have a big problem with a Plockmatic BK5010.
The stitching is exactly in the middle of the sheet.
The fold is suddenly offset by 1-2 cm.
I still have to get 400 brochures ready...
Good evening,
I cleaned and re-lubricated all the lubrication on the spot. Today it went through the entire production process without any errors.
It was really the mistake that the lubrication...
Hello,
46235
I have now removed from under a metal sheet and so I can get the component. Everything is required on the side and moves safely and easily. I have now tried it from below while...
Hello,
ok I have to see how I can expand this. When I start the component in the service menu, it starts up and down normally. The whole thing adjusts itself appropriately from the paper...
Hi, I'm looking to get such a device.
I removed and cleaned the sensor today. If the machine is on and I go over the sensor with paper or my finger, it switches to 1, then it jumps to 0 when I...
Hello,
I just unplugged the sensor and removed it and treated it completely. Nothing has changed after installation.
I have order a Fuse by an electrician.
Greetings Sven
Hello, thanks for your help. I tested it via the service menu.
The sensor is always at 0. As soon as I push a paper through it goes directly to 1 and then back to 0 again.
The fuse is a sand...
Hello, I have a Plockmatic BK5010 with trimmer and squarefold.
The machine is used as a stand alone.
Until recently, the machine ran flawlessly.
Now the sheet is drawn in, folded and...