I agree. This is my personal printer and I like to see it clean, and I have time to make it.
Type: Posts; User: hquang
I agree. This is my personal printer and I like to see it clean, and I have time to make it.
Thanks for your post.
I do believe that all members giving me advises in this thread know way more than me - I am not a tech, just an end-user.
I've explained why I did not take advise in another...
Before and After
480394803748038
Hi Billy,
Thank you and I am actually very much appreciated all the advises from ALL. I do understand that ALL want to help me to avoid non necessary troubles. When not taking advice, I never mean...
I couldn't pull the tray out so I removed the left side and took out the paper behind the tray!
Thanks again femaster.
I get it done. It's quite easy and simple with good instruction from rrrohan.
The circle on top is another screw but photo is dark.
48032
Problem has been fixed.
Thank you,
Hoorah rrrohan,
Thanks to your instruction I've lifted part 1, removed and cleaned part 2.
The only tricky part is putting it back since the screws holes are in deeper level.
Again thanks,
47993
End-user now but still shown Technician!
I AM NOT a technician
47992
How can I fix this?
Thanks in advance
Thanks rrrohan
NO, I am not a tech...I have no idea why someone put 'technician' to me.
I do appreciate your help and ALL other gentlemen in this forum. DON'T misunderstand me please! How can I change it?
the part 1 which is just piece of plastic, no electronic involved.
I may be wrong but still don't see any wiring, cables, connectors connected to that tray. Unless there is a sensor looking at...
Yes I am learning and much appreciated for ALL feedback.
I was in a hurry when register to this forum. I have no idea why Point Roberts....Technician!
I have removed all the screws belong to the part 2 but cannot take it out now I just want to know how to remove the part 1 which is just piece of plastic, no electronic involved. It does not look...
The squeaks have gone rrrohan, Thank you!
I did clean up the rollers and install back - just tested and the squeak's gone. Thanks rrrohan!
My second issue is to clean the DF tray and around since it's dusty and the Dust Off spray does not...
Sorry I thought it related to 'general maintenance'. Should it be deleted now ?
Can you be more specific - I don't get where are the covers?
I have something else to clean. How to remove these parts from the top of the C224? I remove all screws from part 2 but it still get stuck somewhere underneath part 1. I can't find any maintenance...
it's located below tray 1
47975
Hi rrrohan,
Is it the part in the red rectangular?
47974
I need more specific to the location of the printer parts: fuser, rollers, silver shaft... I am not a tech guy but will try my best.
Thanks,
Hien
Hi All,
This is my second post. The first one is a problem with Tray 2 of my C224 and it solved in 24hrs.
This post I am going to ask about the maintenance for the C224.
I use this printer...