Search:

SOunds like e newer i-series maschine? I something like ySoft SafeQ was installed, that is on the SSD, so did you do a format of the SSD?

Google no longer supports scanning from mfp like previous. I did find this wich you can try though Yes, you CAN USE GMAIL with a scanner!!! Here'''s how to set it up: : msp

LoL you are right. I read is as C550i, but just realized it is the old non-i.

1. Did you try re-writing latest fw?
2. can you boot safemode (holding down resetbutton while turning on)?

The only "fix" in fw is that is does not destroy data on SSD. Normally if battery dies and machines is booted it will say "Serialnumber must be entered". You now have to either change MFPB AND SSD to...

1. Is the cyan hopper actually filling. Just open and look if it is full of toner.
2. Run with the lid to cyan hopper open and look if the toner is moving to se of it is actually filling from hopper...

FS-534 IS the correct finisher for C308 so why would you deselect it in fw?

I just had 93-10 on a C558. I adjusted the right door so it tilted counter clockwise. Seems like it did the trick.

You will need to change the SSD AND MFPB at the same time. This will cause all data and counters to be reset.

I have changed the sub hopper assy on these before. Make sure the hopper is actually working correctly or change it.

I have seen this happen before and my guess is that something on their network is sending rubish to the printer IP. Change the printer IP adress (and offcourse also change for each user on their PC...

I have excactly the same issue with a C250i! It can scan/copy from the glassplate, but not from ADF. Paper passage test i CE is fine, but if you run test chart it stops. I am ordering Scanner board...

Only way is to use the "level up" firmware for cxx4 models wich should work. If you are not a KM tech you will need to contact a such.

This model has issues with dumping developer. Especially the cyan developer wich shows up as white stripes on the cyan test page. Not sure if this is your issue, but if you change out the developer...

I have a C3350 that sometimes says "Service Call!" on the screen but no error code. I just formattet HDD, set network to 100 full duplex and ordered SSD. Will update when I know results. :)

Not sure about that model, but on the new i-series you can turn on/off marketplace under Network settings - IWS - Marketplace

I have seen this now and again. first change out the whole stabler magazine/container. If still a problem, then change the stapler unit.

The bearings in the fuser goes bad and then makes that clicking sound. Change the fuser.

I had this issue this week on a new C450i. The solution was excactly as stated above. :)

It may be the paper feed drive assy. I belive it pulls both tray one and it can be defective.