There is a trouble isolation switch in the service menu, but it does not seem to be doing anthing.
Type: Posts; User: jeremyb503
There is a trouble isolation switch in the service menu, but it does not seem to be doing anthing.
Greetings all. KM C550. Was moved to new location yesterday, and now the machine is complaining that drawer 4 is not properly closed, when it clearly is.
Before we order a new drawer (the drawer...
Does anyone know where I can get this part? The one on our finisher is stripped. I checked precision roller and google and no dice.
So I finally go in to service mode and the machine will not let me reset the fuser counter. I can reset all the other ones, but not that one. Any thoughts?
Hey folks, You guys have been really helpful in the past so here I am again. My C550 start throwing the error on the screen last week "Have the fusing unit replaced soon" I ordered a new fuser and...
Greetings to one and all,
I have a bizhub C550 and the imaging units were getting close to EOL so I have replaced them all in the last couple of months. I replaced the 2nd transfer assembly (for...
I was thinking it might be the transfer assembly. Is there a wiper pad or something that needs to be replaced/cleaned.
Less than 10K per month gets printed on the machine. The stock was 80lb gloss on a "Thick 3" setting. It has been printed through the machine dozens of times with good results before.
Thanks for all the help in the past, here we go again it seems. I have replaced all of the imaging units in the last few months. Anyone have any ideas?
2224922250
Well you were right. I remembered that we still had the old second transfer assembly that we replaced a few months ago, I put it back in and viola the machine prints perfectly. kind of annoying...
Not to ask to dumb a question here, but how do I do an emergency stop?
And by the way, thanks a million, I really appreciate the reply's.
I should also note that the end of the sheet with the problems is the one that is closer to the operators side of the machine.
Thank you very much for your reply!
I have attached a photo below. I used the Utility mode and generated test pages, so they are coming from the machines memory not from the scanner or from a...
Is there anyone that could help me out with some troubleshooting steps here?
Thanks.
Not to be too stupid here, but is there are troubleshooting process for this?
Hey folks, thanks again for the great advice in the past, I have another one for you here :D
We are having a print quality issue, as you can see in the image below. I have replaced the K imaging...
Hey guys,
I really appreciate your help in the past. Is there a united copier tech beer fund I could contribute to? :D
I seem to be having a paper feed issue. Please tell me if I can even do...
I am afraid I am an end user. Is this forum just for techs? I did read the rules and didn't see that. Sorry, thanks for all the help anyway.
thanks for the reply.
It seems to be ok now. After waiting a couple of hours I ran a test print and it looks fine. There must have been some residue that needed to evaporate.
How do I do the...
Well now I've done it. Apparently I did not get all the adhesive off last time and the spot started to come back, so I cleaned it will the paraffin and followed up with glass cleaner. Now when I...
I did replace the black toner last week, I will try a different one. Does anyone have the part number for the moded transfer assembly?
Thank you so much for the quick replies! I hate to ask but where would I get a copy of the bulletin? Also anyone have a lead on a good place in the US to buy parts for these machines?
18014
Anyone have any hot ideas here? This job has been run many times on this same machine (as recently as last Friday) without any problems. If it runs single sided it seems to be fine, as soon...