dear friend!
Q6675-67004 this set for plotters with few printheads. I can't undersrtand how
tp use it in T930. But thank you for your help....
Type: Posts; User: White_Toner
dear friend!
Q6675-67004 this set for plotters with few printheads. I can't undersrtand how
tp use it in T930. But thank you for your help....
Dear technicians and engineers!
I have started service procedure:
Service Utilities Menu ---> Purge Tubes-->
with idea to clear pipes of air bubbles.
The plotter warned me that I needed to...
really i'm not sure that problem is in hard disk/
How download SW to a dead machine? PWS need?
Hello dear tech community!
Machine at frst loaded sometimes with frozen second screen with Xerox logo,
sometimes icons without names
There was error 124-310
And now just 116-375
i have pdf...
to BlackCat
Different drivers and different nets - the same machine.
New network card installed- no result/ Fuser warming up.
If UI is active and you print using network, machine goes
to energy...
Hi to all!
This machine goes to energy saver mode after copying
or USB printing. No problem. Temperature of heat roller about 60C
If customer print through network controller, machine prints...
Hello, tech men!
My question is:
I have one machine with fault software module (battery OK)
Can i check it on the another machine that is in OK condition?
I"m afraid to corrupt good machine...
to adriansto:
AT last attempt it was 061.132.226.02000
5790 whith tag 155
I have wc5790 with 61.131.221.10401
don't ask why (machine was in good condition)., but mistakenly was loaded firmware
61.130.000.04205 from usb flash.
As result "printing and copying...
Dear sirs, please...:-)
Did you receive files you need?
I go to buy some beer :-)
see your's private messages
Your's e-mail please.
What kind of problem?
When u turn on copier and it start initialize this message had appear?
Sorry, if my english isn't good for jokes...
The first post was in my opinion about blondes.
Continuation:
One blonde asks another: You know where light in kitchen
disappears if to switch off...
Thank you! Filter was completly full of dust
Hi, mramlawi!
The machint works 2 monthes - enougth fresh :-)
Cutter is in good condition. The edge is clear after cutting - no problem :-(
check your mailbox
Hi, to all techs!
The machine cuts paper without any problem.
Cutter moves to the left, then to the home position,
but roll of paper doesn't rotate back, and message: message: 'cannot cut...
Hello to everybody!
I tried to reset this error by 999-993 e.t.c. but
machine is rebooting after N9 apeears on display
and i haven't time to enter diagnostic mode :-(
Did you meet something like...
All answers are usefull! good luck
Thanks for your help,teckat!
The one question: why printing test or somethinf from computer is OK? Just copy light?
Hello everybody!
Printing no proplem But copy too light. Optik elements are clean. Glass- both sides, carriage, white strip e.t.c. The room is without dust and documents not old. Total copies 144...
Hello! I have problem with resetting MP counter of fuser web. I have service manual. Fuser web was replaced, but resetting code is 3730 - 007 in super user mode. What are the login and password in...