in my case exiting face down
greetings
Type: Posts; User: esvesdin
in my case exiting face down
greetings
yes test page also make two passes
wich bit switch did you mean?
greetings
I check that setting it is o.k that not the issue here .
greetings
I tried from another computer , even with another O.S. ( win 7 and win 8 )again the same , problem is there.I like the idea of an older driver and mobile aplication . I'm gona test it on monday olso...
connection is by IP adresss i'ts not by WSD Port and driver is PCL 6 from ricoh page
greetings
It's not driver , I checked everything in detail and I'm using PCL 6 for a very long time so I'm pretty sure it's not driver
greetings
in copy mode it works fine. The copy does not go to duplex.
greetings
i change default printer to one side print that isnt the issue here
greetings
no exiting face down
greetins
Hello my printer ricoh mpc 307 , always makes two passes even though I give him one-sided printing
any idea ?
[QUOTE=Gift;2219155]54818
I found that one pin on the conector flew out, but visually it was not seen at first sajt
tnx a lot man this is save ma life ;)
Greteengs
the machine reports toner cetridge are not set correctly, please set correctly , I put a new catridge and a new drum unit , nothing happens the appliance again the same occurs
any idea ?
Greatings
Thanks, man, for the answer , I took another unit and tried to isolate the problem , of course the parts are Chinese , but they were working on a "new" unit, the only thing I didn't change was the...
charge roler and brush is new but problem is still there
greetengs
I change the lubricant , problem is still there
greetings
i tried with this exchange but problem is still there, now i take another opc unit i m going to repack part by parrt to see what the fuck is rong
greetings
I believe this is a forum where technicians come up with a problem and other technicians offer a solution, usually when i put the original genuine units i don't have any problems so i don't need any...
i didn't change it i just cleaned it up but it seems to be good
greetings
I did not mention that the problem occurred to me after 10,000 prints
which means that the parts and installation are o.k.
of course it is easier to replace a complete opc but it is much cheaper to change it separately
greetings
hello everyone i have issue with magenda opc drum as you can see in the attached image , the drum is new as the cleaning blade , someone has encountered a similar problem