Search:

Type: Posts; User: Tech-Yeah

Search: Search took 0.00 seconds.

  1. Re: Xerox Atlalink C8170 System Failure PWBA-MDF5-FAIL 341-351-00

    that code doesn't exist on my edoc but if it's a blown fuse, then there is no resetting it. replace the mdm bd.
  2. Replies
    1
    Views
    329

    Re: D125 error 10 330

    if it followed the fuser module, then the issue is right there. i would rebuild that fuser module i know you said you replaced the pressure roll, so it may be the fuser roll bearings are seizing up...
  3. Replies
    1
    Views
    318

    Re: Xerox B8055: Trays 1 and 2 Lift Noise

    normal for this product
  4. Re: [Image Quality] Xerox B8075 - Right side dragging on Doc Feed copies

    The DADF is not seating down on the glass properly. You can press down on the DADF and feed a document to verify. Most likely you have a broken hinge mount or cracked DADF frame.
  5. Replies
    4
    Views
    754

    Re: Xerox C70 duplex jamming

    Drag in the duplex transport system can cause intermittent jams. The brass bushings and the drive shafts will need to be cleaned. Preferably, replace the brass bushings with ball bearing ones.
  6. Replies
    2
    Views
    1,378

    [Error Code] Re: Error code 092-320 Versalink c405

    Did you print a color separation test? If your Cyan is light, you can increase its density by running its toner motor.
  7. Replies
    9
    Views
    748

    Re: Dusty Xerox AltaLink C8070

    Replace the waste auger pipe. The seals over time comes unglued allowing waste toner to escape.
  8. Re: Xerox 7855 jams out of drawer 2 but not three. New rolloers in all drawers.

    It would be helpful if you are including the fault codes, this will give us a chance to help you pinpoint the possible causes. That said, you could have a worn out actuator in the tray 2 feed out...
  9. Replies
    1
    Views
    575

    [CQ] Re: xerox D95 error code 012-216

    I know you replaced the sensors, but didn't specify which. Does the end wall home sensor change state in diagnostics? Does the end wall motor energizes? Retension the end wall motor drive belt. Check...
Results 1 to 9 of 9