If you look closely, it's enlarging the image,maybe near the trail edge. It's not a registration/feed adj issue. Print a grid from the print engine(test page)
Type: Posts; User: Canuck
If you look closely, it's enlarging the image,maybe near the trail edge. It's not a registration/feed adj issue. Print a grid from the print engine(test page)
Did you get it removed? Simple to remove these from machine..under 3 min...lol. Open front cover, thumbscrew to remove bracket for starters..
Do you have special SMB 2/3 firmware installed on machines? And "latest firmware" has nothing to do with it. What Windows OS version are they running on computers?
Me neither. Only if it had corrupt firmware that a formatting and re-flashing would cure.
In the ready state, if you open the document cover(that has the pickup/feed roll assembly on it), does machine tell you to close it?
POP has nothing to do with it. Creating a Gmail account, generating device password in 2 step verification of account to put into copier for authentication, and enabling port 587(sometimes 465) will...
The flash pcb is a controlled part. You need to start a case with Tech Support before you can get one, and you will need to return old one. It's not just a "part: or "firmware" that you can order
Pic is useless. Lead edge and feed direction? And it's out of focus
Do ccd-adj and white levels in service mode for both platen glass and df scanners for starters after cleaning their respective white plates(for shading correction). And yes, make sure df sits all the...
Did you do an Rcon clear? Back it up in service mode then clear it. If still blank, format hard drive and re-install newest firmware for starters. I've had irac machines do this before, and if that...
Once logged in as Administrator, Settings/Reg,Management Settings,Data Management,Initialize All Data. This will wipe out all previous user settings
Definitely. All the newer Canons eat controllers
Error codes logged in service mode?
If it's a 2nd hand machine, I would initialize all data in user mode also
One thing that I can add is that on all these DR scanners, X10C,etc..they all have gears with one-way roller clutches inside of them in the pickup/feed roll drive section...look in the parts manual....
Update the firmware for starters. Pull the boot ROM and any RAM out and clean the contacts with fine sandpaper and alcohol for starters...I've had it on this series(22/38/3300). Reseat Main con...
It's an older high voltage resistor..usually varistors are used. It is for surge protection. A capacitor will get rid of noise, static, but it won't give surge protection
The end of the shaft at the front of the process unit for driving the cleaner auger breaks so the gear has no drive. Vacuum the magnetic roller clean and machine runs clean for a while, then dirty...
The end of the shaft at the front of the process unit for driving the cleaner auger breaks so the little plastic gear has no drive. Vacuum the magnetic roller clean and machine runs clean for a...
Make sure all of the Windows security updates are installed also.
Do you think changing the profile will correct it? Lmao...
Garbage in=garbage out
Yes it's possible. I have had color toners (smaller diameter tube)jammed into 5240 series machines in the black position. Mag in Black and I had the identical issue. Black was magenta until I put...
Probably if you would have pinged your machine's IP with it's cable unplugged you would have gotten a reply,indicating a conflict
FL3-6291. The proper one for the machine. Run it 500k then flip it to the fresh non-yellowed side, wipe with isopropyl, dust with sterate then away you go.