I'll definitely try all you have said -and let you know
Type: Posts; User: amitlama_78
I'll definitely try all you have said -and let you know
Hi
Thank you so much for replying. Actually I posted from different account because after submission i could not see the reply options. -So I posted from different account sorry for that.
My...
Hi
Recently my copier started to print half shadow and half good image. But if copy in ight settings i get the image.
I would appreciate if some could suggest me..
5284352844
Hi
Recently my copier started to print half shadow and half good image. But if copy in ight settings i get the image.
I would appreciate if some could suggest me...
Hi
Im still getting the error e808-0004 i have replace the fm4-1086 but no luck
So today i checked voltage on the main driver pcb board. Fuse 19 is giving 12 volt but fuse 2,9 18 there is no...
The file was printed on LEF (long edge feed) = A4
Images comes on long edge first
No the font is same....
Have printed as landscape (left)
i HAVE JUST ATTACHED THE FILE PLEASE TO HAVE LOOK
Hi guys
I have this machine km754 which prints ghost image.
First copy is ok when i do multiple copies the first copy comes fine but from the second copy on the upper side i get the fade ghost...
Thank u for your reply
I checked all the boards but the connection from the relay assy pcb board to the fixing drive motor there is no current.
Hi Guys
I have an error thats is 808-0004
Previously i had 808-0007, I checked on the the main board and found that fu19 was not working i replaced the fuse and now getting this error 808-0004
I...
Hi Guys
I have xerox 252 which im having problem scanning from adf.
Image scans perfectly but the image shifts down near about 2 inches.
And other is i have just changed my fixing unit and when i...
check ur toner sensor
Hi
I'm also having the same problem. My adf tray does not lift nor does the led light turns on when i insert the paper.
I had also already posted the same thread earlier but could not figured out...
Hi
I'm also having the same problem. My adf tray does not lift nor does the led light turns on when i insert the paper.
I had also already posted the same thread earlier but could not figured out...
Hi
I had problem with my dadf and i cleared the r-con , c-con and now my multi purpose tray is not working (bypass tray)
Kindly help me out.
Amit Lama
hi
no the green light does not light up when i put paper.
Hi Guys
Need help Im still stuck with the problem.
Any suggestions for my problem
is there anyway to check the pcb board or i need to buy
what should i look for now?
Hi
I checked everything and on service mode motor is running and even the sensor. Could it be the PCB board?
Hi
Mine error is gone but motor does not lift.
If I lift the motor manual by gear the tray lifts.
And when I switch on the machine the tray goes down to it's home position..
Cant figure out the...
Tried changing the wire but no luck