SOLVED
Fixing drawer switch under duplex was faulty. Nonsens at all, but that was the prob.
Thank you guys
Type: Posts; User: tinnyjay
SOLVED
Fixing drawer switch under duplex was faulty. Nonsens at all, but that was the prob.
Thank you guys
Different ones. Depend on what paper or size i am using.
Also it happens when the machine is idle, i open and close fixing unit.
Changed fuser unit and interior fixing connector with cables also.
Changed with new ones
Not my case.
I have changed both fuser connector and body/interior connector but still the same.
The problem looks deeper. Could be a faulty Relay PCB but i am not sure.
Thanks anyway
Hi guys,
I have an Ir Adv c7280 (same as c7260) and it gives E04-502.
Changed fuser unit, change fuser drawer and drawer into the machine but when i have to open fuser drawer bcs a misfeed, it...
You have to check if the web solenoid is working. Sometimes it causes this issue.
Also i would suggest to put a piece of paper in sensor with machine turned off. Turn it on and whait for for e-05...
Hi guys,
When i scan color documents from the glass (also from adf) I face E302-003.
Cleaned glass, scanner, led etc, but still the same.
Anyone had a related problem before please?
Regards.
Clean the glass strip inside adf scanner.
The plastic over fusing unit.
_________________________________
Case closed.
The cooling plastic above the fuser unit (also under Fuser IH), was broken and the heat caused E808-8.
Thank you so much all of you.
Regards,
I changed PCB10
The temperature of FIX UE and FIX UE2 is higher than FIX U by 5-6 degrees during printing.
After 1 minute in this state the error comes up.
Can it be heater or side thermistors?
In any rare case...
I did what you said but e808-08 comes time after time again.
Hi,
I changed AC Driver PCB Assy (FM4-1088) and IH POWER SUPPLY PCB ASS'Y (FM4-1092) and still the same.
Hi,
I am facing a problem with ir adv 8105. I have changed thermistors and rollers, but e808-03 and e808-08 come time after time.
Error 808-03 is FM7 because of clogging but 808-08 cant find it....
Barings and rollers are new one and it starts creasing the paper after about 70 copies.
Hi guys,
i had to change both fuser rollers (imagepress 1110) and since then the larger formats like A3/12x18 got wrinkled in the middle of the paper in horizontal direction.
Tried all the ways...
I would not suggest. Its the 8105 & 8205 can't use non-oem upper fuser roller and the reason is the temperature that goes higher and higher till you'll face E004 after 3-5 mins of printing.
The...
I didnt tried a different fuser.
All other parts change periodically (related to quality i mean)
I have adjusted the machine but there is no difference on all my attepts.
Clean/change duplex registration sensor and motor in the duplex.
Its a delay to PS65.
If had to be reverse roller on the entrance of duplex, the jam code would be PS66 (delay).
Clean the laser.
Hi,
i am facing this problem (the picture) and i have changed transfer belt and registration roller. Tried on two different drums, but still the same problem. Also tried to increase and decrease the...
You have a small paper stucked there. Remove all plastics one by one and you will find it. Or could be a small plastic deviance somewhere.
If its very light mostly on photos and if printings got light without changing anything, (options, drivers) i would suggest to reset the printer.
Preferences-Function Settings-Printer-Utility-Reset...