Hi,
What was the resolution to this ?
Regards
Shazza
Type: Posts; User: shazza
Hi,
What was the resolution to this ?
Regards
Shazza
Cannon IPF 770
Anyone got Part Numbers for Absorber Pads X 2?
Only Purge Unit listed in Manual
Thanks
Hi All,
@Teckat .. Anyone got a photo of where this sensor is located in Internal Finisher E1
S14---replace the stack tray clock sensor S14 :eek:
The part number for S14 is WG8-5836-000.
Dowel Pin Missing In Finisher Feed Gear was cure :)
Hi,
Getting above problem on an install that has been working fine for 2 weeks but only 800 copies. Stopping just at PS1 sensor all of time from all Trays and Bypass. Works fine when Internal...
Just called him. He did a Dev Init
Hi Guys,
A colleague has a failed install after 700 copies with E20-04A9 . He has replaced Black Drum & Dev Unit with no joy.
Printing Full Black page then errors
Any ideas
Thanks,
Hi try Below .
I have had similar problems when goimg down Driver route and Autograd with correct media type Resolved
[Cause] These may be due to the correction of image gradation...
Try Below
[Symptom] Timeout error in detection of M Toner Bottle Seal/Release Sensor
[Cause] Failure in detection about the changes of ON => OFF => ON with the sensor when the cap of the M...
Hi,
Sure you can delete or reset my account settings etc
Thanks
SHazza
Hi .
Does this mean the Site PM message is still down? I was trying to send a PM bit it will not allooe
Hi
My account is having same problem. I have 65K Notification and Cant delete or send PM
Thanks for any help
Hi All
I have a small question on the IR 1435i desktops. A school I am dealing with is looking at replacing the printers in their IT rooms with our small MFD's. However, they would like to disable...
Thank You Thats Brilliant.
Hi All
Posted again :~)
Can anyone post an updated Canon Firmware Chart if possible ?
Thanks
Hi
Check senor
FC9-0822-000
1
LEVER, REVERSE SENSOR
Hi All
Can anyone post an updated Canon Firmware Chart if possible ? Very usefull
Thanks
Shazza
Hi
Anyone know the part Number for 3 way unit Complete for ir A52XX range
Mr B?
Any Ideas
Hi,
Has anyone got part numbers (Mercury) for Above Finisher?
or even better up to date part numbers for all accessories for all Devices
Thanks
Shazza
Hi,
I will check next time on an irA 50 XX . Does anyone have a desktop simulator like we used to get on the old devices. It would be very handy to check thing when not working on a machine and at...
Hi kl568,
Still no luck but got round it by setting up a favourite shortcut directly pointing to the folder on the system so hopefully that will stop customers messing around wit h register new...
Hi Guys and Gals,
I have set up a one touch button on scan and send on a machine with Unilflow. Is there anyway of disabling or graying out register button as customer wants it disabled as only...
Hi,
Anyone know or had error E000003-0052. on a ir5880
Any advice would be welcome.
Regards,
SHazza
Hi All,
All sorted now replaced all 4 sensors and adf solenoid to cure!!
Thanjks