Search:

Pull ya head in mate. No need for name calling hero >

Check the fuser connectors inside the device cavity . Just in case they're dirty / damaged or have paper stuck in them.

Hi mate,

Have you manually entered the correct paper size in the device ? If you are using the paper catalog, you could create a new entry and then change the size to the dimensions of your stock....

Hi Mate,

What's the distance between Bands ? That's often a clue. If its on all colours it might be wise to clean the encoders on the ITB unit.It normally causes mixed colour banding and usually...

The 2nd one is correct mate, cheers

The Gears do go after half a dozen or so rebuilds.It's important to put new grease onto those gears at every rebuild.This will help them live longer

Upgrade all device firmware to the latest version . Also upgrade the ACD unit firmware.

Good luck

Try Firmware first , if still no good the manual says to replace the DTU.

Well said sir ! he's a serial offender on a very high horse !

If you had read more than just the thread title you would have seen that he said he has replaced the Registration unit

I did read the story mate. I have seen on more than one occasion, when techs have replaced the feed station, the feed issues reoccur due to leaking developer contaminating the new feed station.
Hope...

Check that the Dev unit hasn't shot it's load at the rear. When the seals go , developer pisses out and goes thru the feed stations gears and torringtons.

Is the machine level from front to back ?

Only trying to help mate....jog on .......

45642
Here you go mate, hope it helps.
It might need a new Dev unit.

Hi Mate,
I'm pretty sure these are the same animal, the only difference being the C6502 being a 65ppm unit and C8002 being an 80PPM unit.
From where I am ( Australia ) , The fuser is the same.

Hi mate,

Are you getting and comms related SC codes eg- SC919 ?
Have you tried swapping out the ethernet cable from the RIP to the engine?
Could be any number of things .

Check the duplex unit connector/s and the connectors in the device cavity for paper caught in them. I had this cause similar issues. cheers

Any SC codes generated ?

Hi Mate,
SC990 can mean many things. There's usually a line of data that accompanies it.
For example if has some like SC900 : ProCon xxx, It could mean there is a problem with Devices process...

Have all the filters been replaced ? especially the Ozone ones ?

Try Reset,8,0,6,1,8,2,C

Hi Mate,

Its the yellow unit.

please see attached description

If you've already replaced that part, it could possibly be the belt lift HP sensor at the back of the ITB unit.Or the lift mechanism itself.

The best way to check the lift motor unit that you...