doing it on copy jobs too. strange how replacing the door fixed it for 3 months and believe me this machine gets used alot so you would think it would have come back before then. also i did the...
Type: Posts; User: GUNit
doing it on copy jobs too. strange how replacing the door fixed it for 3 months and believe me this machine gets used alot so you would think it would have come back before then. also i did the...
hi
yes we have this scenario also. had it approx 3 months ago, changed right hand door with a working machine- no good. changed with a brand new door and problem gone for 3 months, but now...
sorry guys position filled
working on latest machines in Kyocera and Develop range. PM me if interested
Just had this yesterday so thought i would put it out there. Jamming intermittently at reg and sometimes skewing and varying registration. went through the usual but what i found was if you take out...
its been a while but i seem to remember you have to pull the print card out when doing the machine firmware or it doesnt work.
maybe this is just a UK problem, as i notice jhalfhide is uk based as am i. i have been with Kyocera from C830 and C2630 days to the present garbage they sell and although you can only speak on a...
im with jhalfhide on this one. we were Mita dealers in the early days when 3035 and the like were king . ever since Kyocera took over i agree toner yields are terrible very expensive to run ie toner...
just wondering what its like if you do single colour cyan or magenta will it be skewed as there are 4 individual lasers just wondering now if someone has maybe been playing with the allen screws on...
if the image is skewed on the transfer belt then you can discount paper feed. if internal prints are skewed then discount optics which leaves engine more than likely laser, maybe not seated correctly...
they are quite some marks. i would think marks that heavy would be easily seen on say a drum or transfer belt etc. could it be some kind of electrical noise/interference on mains? the only thing...
Been doing this for a while now with great success. the neoprene compound works so much better on the Kyoceras. use them wherever you can from printers to small mfps to the 8000is. on some they just...
Take the lsu back out just enough to get to the motor and then wrap tape around it. this is in the alfard troubleshooting guide, I think they recommend using the orange filament tape but insulating...
had this before and it turned out to be boot dim on the main pcb, good luck
Think the general rule to follow is if there is a counter for it then reset it, the great thing about digital is there are so many calibrations and compensations for aging and dirty optics etc going...
the fix for this is to reset the charge roller count when it has done over life. unfortunately the majority of engineers when changing the charge roller itself do not reset the count so the machine...
had this many times the problem lies in the black holder which houses the pick up roller and feed belt. there is a little plastic piece that snaps off this holds the unit in a position where a sensor...
this rings a be it ll im sure you have to change sim 956 from old to new or vice versa something to do with conveyancing section I believe, good luck
think you missed the point here. my problem doesn't lie with buying the rollers or any of the other useless parts Kyocera supply, my problem lies with the quality of the rollers. why have a machine...
these tyres are s..t and are not covered by warranty. they should be in the maintenance kits as they will be needed at 600k. we use Konica tyres which work so much better. sometimes you have to look...
if my memory serves me correctly go into system menu then under the copy heading look for priority reservation then enter that and switch it off/on, its along those lines same as ta250ci. hope this...
many years ago we swapped out a canon 400 that was shot. expecting to ditch this beast at the nearest dump you can imagine my surprise when the salesman said he had sold it. ok i thought give me a...
try changing sim 956 from new to old works for me every time. should be no need to tweek anything else. good luck