Change the TCSB Board with a new one.
Type: Posts; User: perdana
Change the TCSB Board with a new one.
Please check black mylar Guide at Main transfer roller, or remove the mylar guide if bent or tear.
Try to Clean or change Power Sub Switch beside the Control Panel.
I have Bizhub 283 machine and the Print Head Flat cable was cut by Rat, Anyone know the Part number of this Flat Cable (2 flat Cable) ? Thanks
I have problem error C-D501 on Bizhub 600 cause by NV Ram, anyone know how to reset NV Ram for this code.
Thanks
The Image is Litle bit longer than usual.
It is part number 6 #4038 5728 03. Thats the only actuator you can order for that fuser.
I think the code is C004E. Power Supply unit cooling fan motor M10 failure to turn.
Yes the drum is interchangeable, but you must change or modified the Drum Fixing Coupling. So they match for the drum.
Try change TCSB sensor at drum unit.
I Have problem on Konicaminolta MFC 1690, They have code Not Installed Toner Check YMCK Toner. Please help me.
I have problem with KonicaMinolta BZ 164, need to change Thermostat in fusing unit. But in part manual we must change as a unit. Anyone have a solution ?
Yes. Ineo 164 using toner bottle better than DI 1610 using toner catridge (saving cost) and can copied up to A3 paper.
Please check conection betwen HV Unit and Black Imaging Unit.
You can fin at Copier Chips Ltd | Suppliers of Imaging Unit Chips or katun.com
You can buy a new chip and put in developing unit.
Adjust ATDC level
Yes, Copyman right, Bizhub doesn't have fuse. You only disable the indicator before they shown by setting Software Sw.
No. you can not. You must change Pico fuse inside IU conector.
Change Chip in toner catridge TN 312 with chip from C250.
You need to replace pico fuse near IU conector 80 ma.
Hi all,
I've Bizhub C200, The machine is dead if we turn on only main power lamp under print button is turn on. I have change NV Ram, DC power Supply but problem is still same.
please help. Thanks
You can use Developing Unit BZ 600 on DI 650 Machine but you must cut off front and rear side plate about 1 cm. That separate Dev unit and drum.
Can we use DV 110 (for BZ 163) in BZ 164 machine ?
I think you must change the Magenta Imaging Unit