sounds like something isnt'plugged in fully
go back and recheck your work
basically if you disconnected stuff and it doesn't work after you didn't get it reconnected
Or you blew up a board
...
Type: Posts; User: CT Copier Repair
sounds like something isnt'plugged in fully
go back and recheck your work
basically if you disconnected stuff and it doesn't work after you didn't get it reconnected
Or you blew up a board
...
WIRESHARK:D
Hey guys
Need a part number
main connection cable FS534 finisher
heres a pic its this one the thumbnails has 2 guess i fat fingered
...
Working on a machine that was bought at salvage (insurance) Found 2 fuses control board blown no 24 volts ( blank image) so had board repaired at hytec
then no output on Hv1 ? in transfer unit ...
Have a machine throwing error code
361.392
any help?
Have a customer running strictly MAC they just upgraded to 10.10 and the machine loses print jobs
Most of the "lost" jobs are Illustrator jobs around 200mb and bigger
Running a built in fiery...
plastipair mcm electronics
Need the fuser nip sensor off an old fuser unit
Thanks
Brian
Looking for a fuser with a good frame
Will rebuild or if its good even better
Brian
203-954-8265
bbrissette123@gmail.com
General technical stuff
mechanical theory and application
electronic theory and application
networking info
PC info
etc
took it pretty basic
here in the states they want 7 years tax...
Canon DADF x1 service and parts manual
anybody help out?
Thanks
Brian
Its on a IR adv C5030 with a B! reader
reinput rcon values
did all the inits
is still not lifting paper
the adf feed assembly does not lift up its in the down position and does not init up on power up
Running motor 0 it tries to...
Need a part number taskalfa 5501i
the connector for the finisher on the finisher
see pic
Need some help
Cassette 1z folding paper 81/2 11 about 1/2 inch wide
jammed it before registration and its folded before was thinking fuser
any help
also manuals and netviwer admin...
Best wishes Paul
You'll be fine in no time
where or how can I get one?
Thanks
Brian
Try to do the calibration from the tray tray and does not feed the setup per the manual
when doing the 2nd adjust from the doc feeder it doesn't lift the paper
and for the life of me where is the...
where is the itb init located
Brian
Where in service mode is the ITB profile created ?
I looked but then again Im dumb and its Friday
Brian
And the 1 on position is the flag actuated out?
I think the machine was dropped and I remember reading that these things are really sensitive and need to be perfectly square or the E75 is an issue
...
Machine goes into error
first ti,e found the spring popped
reseated it and it tried to make a copy and jammed
found broken paper actuator so I replaced that
now in a hard e075-002 again
Looked...
whats wrong with my machine?
my answer BROKEN
well what are you going to do about it?
my answer FIX IT?? lol
I r a tecknician and I no plenties
[QUOTE=CT Copier Repair;402726]thanks paul
already have the manual[/QUOTE
just got to machine and the developer is dumping everywhere
Development brush looks wrong. 8.5 mil on developer unit...
Arcing for a corona
I would restring all of them looking very carefully at everything
Clean all the blocks check drum area for anything in it
Make sure developer spacers are good
Brian
thanks paul
already have the manual