I have attached example. Scanned off of the glass. Change in resolution does not help.
Type: Posts; User: tomcatt
I have attached example. Scanned off of the glass. Change in resolution does not help.
Documents that are scanned have a faded horizontal stripe in the middle of the page about an inch wide. Copies also but more obvious on scans. Prints are fine. I imagine it is a problem with the...
Thanks. Confirmed the 4503 power supply worked in the 3503 although different part numbers.
Will a mpc4503 power supply work in a mpc3503?. It looks like all the connectors are the same with an extra 2 pin connector on the 4503. I will try tomorrow otherwise I will be ordering a 3503 power...
Could be ... I did check and both toner motors are working
I have a Sharp mx-b455 machine out there with a high meter 600k and does not seem to be adding toner. Has any one seen these toner motors fail?
I have had better luck doing a search on the main page and not in the particular forum
I replaced the nvram to get rid of the third party print software that I was unable to uninstall with any success...
In the end I just got it working by doing an memory clear All rather than just...
Looks like I have an nvram for a 4504 trying to work in a 4504ex....I thought they were the same...
After replacing the nvram on a Ricoh mpc4504ex all the apps and icons are in japanese. I have looked in the manual but with no luck. I have tried 5-009 to get language but that doesnt seem to do much.
Ok thanks .
I think the HP DesignJet Z6 or Z9 would work.
Ok good to know. I will look into the Canon ipf as it looks like hp has nothing that will work.
I have a customer looking to purchase a hp plotter- 24 inch - for full color posters. I will recommend the T650. It seems that the best way to handle this transaction is to have the customer go on...
I am stuck on a Ricoh pro907 that jams intermittently only on duplex. I am getting jam codes of 019 and 069. The second side registration is definitely off and it seems to jam at the registration...
So...its the metal bracket that mounts on the copier ..?
Neither Hytec or Nationwide will repair this board anymore
I am in need of a power supply for the Kyocera ecosys fs-c5015n Part # 302d945920
or
If anyone can recommend a board repair place that help.
Thanks
I am looking for a good power supply for a Kyocera ecoys fs-c5015n printer . Part # 302D945920
Customer just got a new Sharp b455. They use twain ( pc scan) and are unable to print while machine is in pc scan. Once they end or close out pc scan the job prints but it seems like they
could...
Looking to get feedback on the MX-B455w machine as an upgrade to the B402 . Most importantly can it do twain scanning. I think it does but want to make sure. Anything else would be appreciated.
Yes. I have with no problems.
I have had a few units fail around 30k on a new machine but after replacing the entire unit they are over 50k and good to go. I am thinking just bad units on new machines.
I have a customer looking for a small folder inserter.they have a pitney bowes di200 that has various problems.
I was looking at the Fpi-600 but would like to get some feedback or new ideas??
I have a parts machine ir105 if you need the motor still
I have a Ricoh MPC3002 just installed print drivers and scan folders on the server. First thing in the morning the Ricoh printer is offline. After unplugging and plugging in the ethernet cable the...