no not yet will this today
Type: Posts; User: mita
no not yet will this today
My operation panel touch screen not responding. Tried reboot several times no luck and checked connections.
Are you using brand or generic toner? It looks like toner staining on the transfer roller
TASKalfa 300i stuck on "WELCOME"
Are you using brand toner?
It is usually 302K924782 the plastic housing cracks and the worm gears pop
0104 Wait for ready of conveying package
Conveying package won’t become ready. D
0105 Driving prevention A drive does not stop.
Check your switches in paper convey
Look at the mechanical levers/pivots for the sep rollers they are sluggish from the factory and don't move well. Also look at the pinch/convey rollers where it feeds into the vertical convey you will...
You may want to have a look at the power coming from the wall.
A possibility is also the pivot mounts for the separation roller is sticky/sluggish a small drop of light oil fixes this. just my 2 cents worth
And the convey/pinch roller springs on the feed head...
Try turning off snmp
I had a 6002i that was doing a similar issue the engineers wrote some special firmware for it and it has been working since then. (about 4 months ago)
Once the Data Security Kit is enabled it marries the machine and there is no way to remove it. There is newer firmware for the panel locking up.
There is new firmware for the panel lock up it is Eval ver. for it
Try using fresh paper, as far as image registration the actuator can wear down over time and cause that and jamming. But I have mostly seen this on high volume printers. Is the image off by the same...
Check the upper limit switch arms on the finisher tray,they are probably jammed out of position.
It's set under the defaults for paper output (fax)
Page 14 item number 9 of the parts manual
302NK94030 here is the part number if you need it.
Look up the result code in the fax log, Are you on voip or standard land line? If voip set the settings per the bulletin and try it again. It can be hit and miss
I had one the toner supply auger was caked, not terribly packed and caused the same error. (The one that moves toner from the bottle)There is a small motor that runs the auger, so I think it has a...
Have the units been replaced before? Or are they the ones from the factory? If replaced and power was still on you will get this issue,and you must also run U952 at setup and any unit replacement for...
On the log was 0519 and 0000 the customer complaint was the machine would just stall and sit in "processing" the would power it off after it started this and have the jam. It seemed more like it was...
I have found several of these machines with gaps in the rollers (assist) on the pf units causing jams. Kyocera hasn't released a fix for this other than to say stretch the spring. The roller is...
I have also found the fan above the main switch to be clogged and cause this issue. It's always worth it to check and clean it out on a service visit