Replace Drum.
Type: Posts; User: ARUN MISHRA
Replace Drum.
Sir' namaste 🙏
Thanks for your reply.
Yes' You indicate right point. That problem in sensor flag at green handle locking sensor system.
The problem has been gone yesterday.
That is very...
No I checked there is no paper, no tiniest paper in fixing drawer connector
Finding something interesting
If I open fixing drawer and close in ready mode machine show error code 197-0008.
Copier printing 100-200 sheet and suddenly a jam accuring. I remove jam papers then fixing unit inserted then machine show code 197-0008.
On and off machine code gone.
Then error code coming on...
Thank for your valuable feedback. Problem solved now. Internal delivery rollers change. Problem solved now.
Paper Jam with jam code 0112.
Some time printing 25-50 sheet than suddenly jam with jam code 0112. Please help I am tired.
Which PCB is power supply, main 1?
Canon ir advance automatically restart when printing a job?
I changed hdd. I reinstall firmware. But not solve the problem.
It is still restart in middle of a printing job. Some time working good...
If i using second deck2. Paper jam with jam code 0208.
Paper Jam in pre resistration plates. If i give 2 copy , only one paper pickup and jam with jam code 0208 pre resistration plates before right...
Yes,
Cassette 4 frequently paper jam with jam code 0106.
I try change feeding unit 3 in no.4
But problem same.
Same paper tray 3 working fine but tray no. 4 show jam after 10 to 50 sheet.
Replace...
I need ir adv 6275 firmware. Hdd dead. I HDD replace.Please help me. I have sst. My email is copierpoint@gmail.com
Problem solve.
That is duplex connector fault.one power pin is bend.
Thank all.
Machine make a jam with jam code 0113.
I have note no duplex motor run in part-chk mode .
Duplex flaper solenoid is not work.
Machine located in rural town .
What i do?
Give me your sagession....
In transfer corona separation wire is not working properly.
Check hvt pcb.
If separation is not work .second side printing
Time paper upword to drum and case jaming in fixing and print have a...
Yes full heating unit.
Teckat sir saying you whole story.
Nothing is outside .
I think this is shorter, finisher, unit problem.
If machine have a finisher unit , than try you disconnected from machine and try a check.
If possible change heater.
Try change copyboard Glass only. And adjust ccd.
Change toner only
Check transfer corona.
Check separation wire in transfer corona assembly.
Try change toner.
Thanks for responding.
Thanks for your sagession especially thank Teckat for give me a best solution.
Finally finisher controller is faulty.
Thanks
Machine dispay ,set the finisher as far asit will go,and close the front cover.
What i do?