I know the original problem is ancient but I have found that the spring disappears off the actuating arm for the registration sensor, leaving gravity to work the arm. This tends to account for the...
Type: Posts; User: copy king
I know the original problem is ancient but I have found that the spring disappears off the actuating arm for the registration sensor, leaving gravity to work the arm. This tends to account for the...
I know the original problem is ancient now but I have found the spring disappears of the registration actuator sensor arm and just leaves gravity to work the arm. This normally accounts for the fact...
I've seen that happen where the machine is in a confined enviroment and has its fans blocked or is just too hot
Thanks for that but with the fault I had the machine wouldn't engage on any level. I was unable to run the firmware, unless theres a more 'forceable' way of running it ?
Not sure, but I imagine its probably PCL5e. I will clarify that.
There is only a slight difference in the manifested fault, some characters on the page change totally (to numbers or symbols) but...
Excellent, that all sounds familiar. I'll let you know how it goes. Thanks.
Thanks, not having worked on this type of software before I'm not sure if the ppd's are any addition to me though.
I cant actually install a driver on this software, it appears to be all built in...
I have a customer running a linux based software package.
When they print to the KM 2560 it will randomly alter : fonts, caps, sometimes the character and it will toggle between bold and normal.
...
I've just had the same issue resolved. Unfortunately it involved turning the machine over to Oki themselves.
The machine has lost all of it's market location identity and has reverted to the C9800 G...
I currently have a problem loading firmware onto a KM2560 and vaguely recall somebody mentioning something about this switch when the 'blue spinning cd of death appears'
What is the procedure for...
I have found that customers being customers open and close the door when the machine says 'replace toner' just to get their job done. They then starve the dev unit of toner, you need to run the toner...
A lot of people these days are buying 'after market' toner and this doesn't always work overly well with the genuine toner when mixed. 1st port of call for me would be to clean out the devolper unit...
Thanks for that, info on scanning is often sketchy at best