Thanks for your reply.
Can you give me more details? What do i have to see under network security?
Type: Posts; User: ricoco
Thanks for your reply.
Can you give me more details? What do i have to see under network security?
Are you refer to the configuration page? If so, yes i did but i couldnt find the HTTP thing...
The SPīs for WEB and TELNET are set to 1
This machine is set by DHCP
Hello BakaBandit.
I tried that solution but when i try to access telnet to this machine it let me enter the user and the pass but when i type show... nothing is displayed. only shows the blinking...
Thanks to all.
I will try tomorow.
Once again thanks
Thank you all for the help.
May i ask one more question? What about the SNMP in the @remote?
Why isnt like the others in HTTP??
Is there a relation with this SP? enable or disable??
I can not find this SP in the manual. I wanted to read what it say
Thanks!
Is there anything more?
The customer is very far (actually the only access is by plane). I have someone there that will give me some help but i what to have all the information with me....
Hello!
I can not access WIM in one of my machines SPC411.
When i try to do that the browser dont open the page.
I can see this machine with Smart Device Monitor but when i try to open it......
No, not at all. Probably you need it because it is a Win. Server, right...
It was just curiosity.
rsyarcia is right. This models do not support SSL. Only the newest version of controllers alows you to do that.
Although you can try. I've seen it work with the MP171 (the controller is basically...
Sharpen my curiosity, why set up Win with IPP?
Just for shore. You want to set IPP for MAC right?
Try to desconect the Laser Unit and turn ON.
I had the same problem once and it was the Laser Unit.
Yes, that was what I was referring to. And it makes perfect sense because the machine was moved after repair.
Thank you for your concern
Thank you Teebee. I will see the mirrors or samething that could be bent.
I will keep you posted.
Once again thanks
That's my dilemma Eric. Already rectified leading edge and trailing edge. But i cant find any SP for skew.
I will see again the mirrors.
Thank you. I will keep you posted
Thank you all.
Eric is there an SP in scanner that a can adjust the skew??
Hello!
I started a post a while ago because a had a problem with SC400.
Tried everything with no success. After rethinking again the whole problem i went back to square one. Redid the whole...
Hello!
After rethinking the whole problem i went back to square one. Redid the whole diagnosis and found that a pin of the plug (ID board) was bent.
(When i saw that i just wanted to give a shot in...
Yes, Jonezy999 is right.
It happened to me... tried and tried. Almost made a fuser with part... and no success.
I understand you but Change the all Fusing Unit. In the end it will be less expensive
Today one more PCU defective (MP171) with 6000 print.
Resolt: SC500
Take the SMC report and see if Approximately one minute after the power is turned on, SC553 after SC991 is displayed.
The connector between the fusing unit and the main body was cleaned, but the...
You have to see 2 things:
1š the swith door
2š the sensors. In this case it happened to me a broken gate in the fuser that actuate a sensor.