Thank you. Issue has been resolved. like you rightly pointed, DP brackets were not properly aligned. Followed the procedure in the svc and everything came out good.
Type: Posts; User: temas
Thank you. Issue has been resolved. like you rightly pointed, DP brackets were not properly aligned. Followed the procedure in the svc and everything came out good.
I have a newly installed TA 3253 from box. Everything was fine after setup. customer called three weeks later that images being scan/copy from both DP and platen glass are skewed. Went on site and...
could you please point out the Spring to me here? see the attached.
i couldn't find any as part of the tray mechanism.
I am having same issue on a TA 3552ci. Internal finisher 7100.
> upgraded firmware
> used U240 to check DF tray motor operation ( moving fine when exit tray is cascaded but jerks when tray is...
Hi guys, so just resolved the issue now. It happens that the toner motor was having a loose connection. Motor is to rotate clockwise/counter-clockwise depending on if you are doing container mix on...
Customer called in that machine is showing "Check toner container". we advised them to check with another toner ( apparently new one) same issue. i visited the site, went through the normal routine...
Registration manual or Auto?
Auto wont work. setting manual registration is hell of a task
464 has calibration option related to registration. this resolved the issue the 1st time. or could it be a...
can you please give a pointer to those things to look out for?
2016.03.08. i will ask a site engineer to get me the maintenance report to get the transfer belt count.
what else should i be looking at?
regards
Please help...... I have this TA2551ci at customer's site, it jumps color as shown in the attached. I performed 464 on it and color became normal.
After two weeks customer called again that issue...
Done! Thanks man!
Hello mate. can you please share link to the service bullettin. i need to convince a customer. i have access to the kyoceraextranet but cant find the bulletin.
regards
@zaza.....do u mean changing the engine pcb?
@ black cat.....lol sorry 4 my wrong use of English i meant simulation.its not entering with 10871087.any other advise? the fusing unit and power board are OK.
@blackcat no!!!!!!!!
@ black cat.i have a km1635 that is bringing this error c6000.fuser unit and power board are tested OK on another machine. i cannot enter stimulation mode to clear the error.what can be the cause of...
please i have a km1635 at a customer site, it bringing error c6000.the machine is not allowing me to enter the stimulation mode to reset the error.the fusing unit and power board has been tested OK...
Please house, how do i reset my fs5200d network card.am havind issues with ip filtering
please house i do i print maintenance report from FS printers e.g FS4000DN ,FS200DN etc.i need the to clainm warranty from kyocera.........
the issue is, am having a problem with km3232 black dev unit,then again i have a km3232E magenta dev unit i want to replace the black dev unit with.the magenta toner was flush off thekm3232E dev unit...
please what do u maen by collar issues?
hello house,
i am new to this forum.please what are the major differences between km3232E and km3232? are the developing unit interchangeable? and again can i use a new magenta dev unit in place of...