Blue rod is corona cleaner not printhead cleaner.
Type: Posts; User: Woxner
Blue rod is corona cleaner not printhead cleaner.
Put windex on cleaning rod and clean printhead/ laser. Think it's a print head on this old girl
You would be nuts to put RB on right now. it just came out on the 18th. Give it a month for bugs to be worked out
2nd that on lifting the corner. very common. i have never had to ajust the ccd on any machine
8 series toner works better then I series toner. Doesn't have streaking problems
the silver eject plate gets jammed. had this last week. look down in the exit of finisher to see if it is stuck. you can just push on. i dont think its the small drive motor. it would be the left...
Storage board is the culprit. You can run the diagnostic tool and it will say board is read only. In that case all you can do is back up everything and replace storage board
If its rebooting every 3 4 seconds firmware will not help yet. You will need new ssd bd. Because of the quick reboot it does not give time to load boot file
did you reset the fuser using trouble reset? use the utillity key or reset key, turn on machine wait for dot in screen touch trouble reset. turn off then back on
Do the error reset properly. There is not a no to select. Hold reset down turn on machine. Wait for dot in screen. Touch trouble reset the turn off and back on. You can also hit system reset under...
Replace the fuser it could be bad wire according to code. Or if you did not turn off and plugged fuser in you may have blown mfp.
C392B: Fusing sensor wire breaks detection (difference of...
What size usb drive are you using. Sometimes 8gb is best. Other problem could be hdd or mfp.
Just because usb worked on one machine it might not work on others. Seen that happen. Also do these have...
Q6 has a known problem for this. Thas ts why it was taken off site. Use P8. Thisd goes for all small machines
No its not the same. 284e starts with a61f
If you dont find a paper clip check the frame for gear drive on top door. There is a bulliten on this.
my two cents is the itb roller is not sitting down on drum. i have seen these break and do this
cloud scanning is comming to I series
i never saw anyone buy the second HDD. just save a back up on there computer.
helps the ccd read the light intensity. kindof like the white roller on the newer feeders
one thing about these machines is you need to do stabilize and reset the gradation then stablize only. I have not had these fail after doing this.
Gofile - Free Unlimited File Sharing and Storage
Gofile - Free Unlimited File Sharing and Storage
one is preventive firmware and the other is recovery. give me your email and i can send it
doing the set up directions has always fixed this for me and other techs. the front of the feeder will always look like it's up a little bit. not like the older series where it was flat on the front....
did you select device 2 and card in service mode stop 0 9
That is not oem. KM is stopping the use. Its crap. Doesnt fuse well. Also runs dirty.