I met this problem a number of times and the solution to this would be changing the power supply board or the RAM and the problem could be solved.
Since these are old machines,the power supply...
Type: Posts; User: COPIERTEC ASSOCIATES
I met this problem a number of times and the solution to this would be changing the power supply board or the RAM and the problem could be solved.
Since these are old machines,the power supply...
I bet you will need a qualified tech to fix the problem on this particular model.However,this problem generally occurs from the HVT pcb which may need replacement depending on the age of the machine.
Try reseat the boot rom and the rams on the logic/printer board to clear the problem,it is more probable that the Boot ROM does not boot up the machine.
also try to reseat the HDD and re start the...
please check your e-mail
I got this firmware for free from this forum through technical brotherhood and i give it for free send e-mail through ;atellellajames@yahoo.co.uk
Hello comrades , i have the above machine giving the error message above and i believe it could be a firmware issue. The purpose of this note is to request for assistance on this issue,thanks
You are actually right the model is e-studio 5520c,and gives the above error. could you be having the firmware within your achieves,thanks
Hello comrades i have the above machine with error mentioned above,upon switching on the error cannot find HDD data props up any ideas appreciated thanks.
Try to check the IH power supply for possible dry joints and connections
I had a similar experience and did the following to overcome the error;
1. check the thermistors if they are ok make sure they firmlly seat on the heater roller,however during the web drive the...
Thanks for the input actually the service manual has nothing to that effect.
Hello comrades i have this printer showing the above error but continues to print.
The purpose of this note is to request on any skill of how to reset the error message,thanks.
Which operating system of the pc does your client have
The bearings are readly available on market in my country
what do you mean by High capacity tray? However if it is the usual multi purpose tray 3,there is an adjustment screw at the extreme end that you are supposed to slowly adjust for the machine to read...
I would suggest you change the laser unit coz for your pdf even the test print shows the line.
Thank you so much for the firmware and may God bless you and continue to guide you throughout you life.
you have really shown a spirit of brotherhood.
There could be poor alignement of the rollers on the duplex unit,check the springs and tensions in the duplex.
Under service mode do a DC CON clear and re-start the machine ie COPIER>FUNCTION>CLEAR>DC CON,then switch off and on the machine.
May God bless and continue guiding yuo
1. Do you have the new exit roller itself?
2. If you have the shaft roller,pull out unit 1,at the exit there is a metal plate attached with 2 screws one on either side unscrew to detach the plate...
The fact that the font report is ok ,it means the laser unit is ok.
Try to clean the optical fibre on the scanner with a cotton wool or clean cloth with spirit.
If the copy is still faint clean the...
Also try look at the sensor flags from the fixing to the duplex unit the may have a delay in getting back to the home position.
Try to look at the selonoid play as it actuates the flapper.
Canon hdd can never be clonned you can only get the original canon hdd and install the firmware
Thanks blackcats i will do the needful and get back to you