no , its first sheets take up problem , but thanks for the reply
Type: Posts; User: pinspin
no , its first sheets take up problem , but thanks for the reply
Bizhub C287i
Hello , friends . May be anyone else had a similar problem - DF 633 makes random jams 6602 . I replaced Feed Roller Assy and Clutch A161M20202 , but it did not help . I would be grateful for any...
We performed all the recommendations, the problem is not solved. Thanks for the advices, we continue to diagnose)))
Hello. When turned on, the lamp lights up, the scanner starts moving and the copier shows the code C 9401. We replaced Led exposure unit, CCD unit, SCDB, CPUB, Baseb,power supply, flat cable, storage...
Done .We replaced torque limiter and used Paper feed Guide ( with white rollers ) . Thanks for help .
Yes ,we replaced 2 oneways and A7AH - M205 , A7AH-M204 .We will change torque limiter .Thanks .
oooh ,you are right friend , 20-02 my mistake .thanks
Hello! The copier jams from the second cassette, code 20-22. We changed 3 rollers and 2 clutches of the second cassette. It did not help. We would be grateful for any advice. Thanks.
It was Dual Scan Image Processing board (DSIPB) .
Thank you very much for the help
The copier, when turned on, goes through most of the loading stages and at the end freezes for 5-10 minutes. Then it spontaneously continues downloading and works as usual. We performed a firmware...
didn't back up ,disk formatted
No, HDD has been replaced
Hello . The copier shows the E305 code, it does not interfere with the work. How do I cancel a message? We will be grateful for any help. Thanks.
Аt the end it was MFPB, thanks for the help
the black dev unit getting emptied into the WTB
replaced
all parts are original
Hello ! The copier prints black spots and the black developer moves into the waste tank. We replaced Black Dev Unit , all Drum Units, Transfer Belt , all Power Supplies. We will be grateful for any...
Thanks , I will re-set connectors. The buffer assy is new.
Hello . We replaced Buffer unit ,DC Controller PCB,Main Drive PCB , but it did not help. We will be grateful for any help. Thanks
It was a problem with the contacts on the boards.
Hello, the copier restarts when it receives a print job from the network . C D341, C D262 errors are recorded while. Disconnecting the HDD does not help. Firmware upgrade also does not start . We...
We replaced the memory module - the copier works correctly .
Hello . The copier sometimes begins to make a gray copy of the back of the original. After turning off / on, the quality is restored. We replaced the Main board, but that did not help. We will be...