in 90% of cases, I only change the housing. In some cases I also had to replace the motor and gears.
Type: Posts; User: granata
in 90% of cases, I only change the housing. In some cases I also had to replace the motor and gears.
thanks a lot:)
sorry would it be possible to put back the solutions for the bizhub c 3350i? Thank you very much
thank you do much:o
very good:o
exactly, I confirm everything that has been said by colleagues. Plus there is no technical bulletin on the case in question
46219
hi,check A267-3440
check laser unit
I had a similar problem with a carbonless paper used by the customer on a utax 5030dn, the problem turned out to be the swollen transfer roller on one side due to the acid contained in the paper,...
excellent, good:o
there is certainly a short on some connector that does not allow the engine to process the serial numbers of the groups. Turn on the machine with the loads disconnected and test until it generates...
wire?
hi,PARTS PWB DRUM DLP CONNECT ASSY SP(302L794030)control this:confused:
Unfortunately the solution is to set smb v2 / v3 on mfp, if available, or set scan to ftp:mad:
maybe a lump of toner on the black development group, did you check?
The developer section consists of the magnet roller forming the magnetic brush, the sleeve roller forming
the thin layer by replacing the toner, the developer blade, and the developer screw mixing...
Reinstalling the developer unit The developer unit is not properly installed. Reinstall developer unit Y so that the connector firmly connects. Developer Unit Replacementand after control drive...
the problem encountered in the field and the dust of paper that settles in those points. replace the pad and solve the vibrations:rolleyes:
it should be this code (ugly part list): 302fz94380
hi,change itb unit
I have solved the problem by replacing the mylar on the cleaning group itb.if disassemble it and look at it in profile and you realize that deformated.ciao:D
I agree with all of my colleagues, I add that a good technician should not be afraid to make interventions and above all should never be considered superior to others and come in short, must be...
sickly machine, without counting the cost of the fuser (700 euros); much more powerful 430 dn though more expensive, greetings
Hello I solved by putting a shim between the spring and the screw that presses the hinghe, same problem solved on 3030 df mpc2800
Part forgot to list entry 17