I heard what Trump has in mind for new cities, he's talking about sending all liberals to the Moon to figure out how to grow food for survival because no one is coming back for them.
Type: Posts; User: Tech2002
I heard what Trump has in mind for new cities, he's talking about sending all liberals to the Moon to figure out how to grow food for survival because no one is coming back for them.
Thank you for this info!
I am having the same issue.
As I am reading this thread you changed the Right Door PWB and not the sensor. You don't happen to have the part number for the PWB, do you? I need to go to the...
Appreciate your input!
And the answer is - Fuser Gear Clutch. It was that simple - but it always is when you look back after the fix. I want to thank everyone's input. This was one repair that had lend itself to multiple...
Thanks for the detail on that. I am waiting on the power source. I am finding out
that there may have been an issue with the outlet. I have an Innovolt on the system
and will be able to get a read...
What made you think to change the Fuser Drive? Did you try other repairs before that change?
Did you have the issue with both Printing and Copying? Single Sided and Double Sided?
Unfortunately no solution yet. Their IT changed the Print Driver from Server
Based to a Computer Install. Doing this is not a bad thing to see if it
would cure the issue - but, when I have run a...
Was the Print/Copy issue an occasional issue or was it print/copy light all the time?
Thanks. I'm being tested.
What I thought was a cure did not yet work again - That was changing the Transfer Separate Drive Unit.
Got a email today from my client telling me we are back to square one.
I'll update when I...
Finally, I think I got it figured out.
Things were slow figuring this out. I have been sick Covid and was researching.
I changed out 2nd Transfer - It helped but did not completely resolve the...
I was looking to see if by changing out the Transfer PWB
took care of the issue.
But I will check that this coming week.
Thank you for the input!
Thanks for writing out your story on this one.
Our story is identical.
If I can find a cure, I'll make sure to post it here.
When I changed out the Primary Transfer it was the whole unit.
I forgot to add that I have done a 61-1 Laser Check - Good
Firmware has been updated to most resent.
The issue I have described...
Re: SHARP MX3570V
I have found out the following since I started this thread -
Client is having the imaging issues whether printing or copying.
Last week they were doing a lot of printing for a...
Thanks for the input. I'll hopefully know more tomorrow Monday the latest.
I have found out the following since I started this thread -
Client is having the imaging issues whether printing or copying.
Last week they were doing a lot of printing for a conference they...
I'd show a sample but the clients info is on that sample.
I have been sick and won't be out physically to the client until probably tomorrow.
I'll have an answer then. Thanks!
Only on print jobs? Yes.
What about copy jobs? I've been told no.
Funny thing of it is, I do know the manual - I just haven't seen this happen before. I thought I'd marry up to what I thought it might be. Thanks any way.
I was told in an email that this happens only when they print.
I am having an issue while printing from the computer.
The print comes out very faint then appears to clear
up where the images are fine. I'm thinking it might be
the lower heat roller lamp.
...
Thanks for the reply!
No worries. Life's too short. Appreciate yours and everyone's input. Have a Good Weekend!