Search:

Type: Posts; User: J-Tin

Search: Search took 0.01 seconds.

  1. Replies
    10
    Views
    1,633

    Re: Kyocera Taskalfa 3051Ci

    You are 100% correct. However, improperly installed charge rollers will cause a nearly identical print quality issue. The difference is that when the charge roller is the cause, it will cause...
  2. Replies
    8
    Views
    1,805

    Re: 5551ci - Error Occurred at Cassette

    Lift motor(s)
  3. Replies
    6
    Views
    2,145

    Re: 4052ci Strange inner finisher issue.

    Install washers around the screws between the finisher's electronic connector and the frame behind it to reduce the wiggle and improve the connection. This has worked on dozens of these machines.
    ...
  4. Replies
    11
    Views
    1,253

    [CQ] Re: TaskAlfa 3051Ci faded colors to the back side

    LSU needs good internal cleaning. If no improvement, may need to replace each of the LSU which are having this issue.
  5. Re: Intermittent 1-1.5 inch Vertical Black Bars on Kyocera 8003i

    In my experience these are caused by transfer belt units, and less often caused by drum drive unit. I've seen this 7 times on the series prior. 6 times transfer belt fixed it, once it was the drum...
  6. Replies
    5,556
    Views
    8,253,145

    Re: Just how Crazy is Donald Trump!

    You've been a technician for 31 years without proper compensation for your work? I feel bad for you.
  7. Replies
    5,556
    Views
    8,253,145

    Re: Just how Crazy is Donald Trump!

    Do you get bonuses for your performance in any way?
  8. Replies
    5,556
    Views
    8,253,145

    Re: Just how Crazy is Donald Trump!

    https://my.beiservices.com/howitworks.php

    I assumed most copier techs are graded with this system.
  9. Replies
    10
    Views
    1,633

    Re: Kyocera Taskalfa 3051Ci

    Most times I have seen that specific pattern it was the main charge roller. Interesting hearing about the worn developer issue, I'll need to start checking for that.
  10. Replies
    21
    Views
    8,478

    Re: Zeus is kicking my ass again.

    That sensor loves to break. I use the grip end of my telescopic magnet to check if it is loose or not before ripping the exit unit out. Glad you were able to find it
  11. Replies
    6
    Views
    1,344

    [Error Code] Re: TASKalfa 2553ci "Error C4600"

    Awesome! Where is this motor located? Is it the motor that drives the laser scanner cleaners? I haven't had the pleasure of tearing a 2 or 3 series down to the LSU yet, but the older models would get...
  12. Replies
    5,556
    Views
    8,253,145

    Re: Just how Crazy is Donald Trump!

    Trump supporters have the worst BEI numbers. That's not me talking, it's science.
Results 1 to 12 of 12