Search:

Check your ribbon cables to the ros (lazer) unit.

If the toner is blocked, it blows F10 fuse on the iot Pwb and the toner motor sometimes burns its brushes. if this happens replace iot and motor... Check the seal on the inner cover( the toner falls...

I've had( look at the attachment, no 9) a tooth break on the no 9(link guide assy) in attachment. Its a black slider shaft that engages the colour dev units. Or the clutch in the no 2 ( main drive...

Does your cyan toner cartridge feed motor run?

If not, check your F3 on your paper handling (iot) pwb... it could be blown...

45333

Australia machines have the software keys in the hideaway hole in the tray, not sure were you store yours. If we loose ours, we get them from our web portal...

044-383 PH F3 Fuse Fail file:///C:/Edoc/common_e2/images/full_a.gif file:///C:/Edoc/common_e2/images/memo.gifBsd-on:CH1.14, CH1.6, CH9.19file:///C:/Edoc/common_e2/images/description.jpg Fuse3 on the...

Its your BP Pwb. as in attachment

094-321 1ST BTR Contact FailThe 1ST BTR Cont/Ret Sensor has not detected Contact(H) the specified time (2400ms) after the start of the operation of contacting the 1ST BTR.

Initial-action

Check...

093-314 Dispense Broken Y
The system detected that the Dispenser is damaged.


The Dispenser Y motor has got damaged- replace the dispenser motor and reset ( test the fuse on the IOT Pwb and make...

Printer Diag > Parameter > Life > Deve HSG PV and it initializes the Life Counter.

hi

Check and change your NVM:

742-205 =

0- 1tm
1-3tm
2-2ttm (3 level}
3- SRA3_3TM

try this

see attachment

This is what I do to all my old Xerox machines using SMB 1 for scanning...

it works all the time...

To enable or disable SMBv1 on the SMB server or PC,
configure the following registry key:
...

Hi
Go back and make sure you have not missed any plugs....

Hi

a new inner cover has come out just for this problem..

802K65485 Inner cover assy..

If you keep getting error 093-314, run the dispenser motor, if dead, replace motor and add inner cover...

Hi

Had same problem:

Changed the AC power supply..

problem solved..

Part: 105E17761 AC UNIT (200v)

Hi

set NVM: 742-180 to 1

problem solved.

Pleasure......Raises the temp.... try it, you will see a big difference...

742-367

Paper Type Detection Limit (Transparency Operation Limit)

Sets the Paper Type Detection Limit (Transparency Operation Limit). 0: Can operate, 1: Cannot operate
This parameter is fixed...

Change NVM location 740-043 from 0 to 1 to enable Coated Mode for
stock weights above 176gsm:
a. Access tools mode by selecting the “Log in/Out” button on the
UI console.
b. Enter 5 ones (11111)...

Had this error code, tried the connectors and leads, tried a hvps. Turned out to be the A.C PWB...

745-416=0

My (020K 10940
One Way Clutch Pulley (39T) x2 were the problem to my jams. replace both of them..

Thanx for the info, did you set it up like a Microsoft windows setup. Scans folder in the home folder with all read and right permissions? ?

Unfortunately SMB scanning does not work with high sierra. Will need to get the ftp app and set it up that way.