Search:

Best to only use new oem drums complete unit not kits or compatible they rubbish

The guys are trying to help you here.
I will guarantee you if you just replace the fuser belt without any other parts it will rip again that will be a waste of your time and money.

These fusers are very reliable a must don't just replace belt you MUST also replace the orange roller minimum. Best to rebuild completely with oem ricoh parts don't buy cheap they are rubbish.

+1

I find in the uk Canon tech support is no way as good as ricoh.

But if you are trained on 4 manufacturers already you shouldn't have any problems.

Good luck

Yes it's a RTB the cold off set the other information re compatible toner is from katun UK technical dept

Thank you

Ricoh is being out of order what about the dealers that buy 20 machines from ricoh for better price then keep in there stock for a year before they sell if got zero mileage on it I would give them a...

Thank you Michael but iam looking for manual including the m40 scanner assy thank you.

Hello

Doesn't matter if the serial number range is in the RTB they will warranty also unless you a very basic dealer you should get 12 months on boards also zero meter and covid tell them to sort it

This technical bulletin is for metis series with is also the mpc3003 it does work also If using compatible toners adjust charge charge roller setting
Not oem tonermpc2003/4 to mpc 6003/4 series...

You would get more help if you make a small contribution to CTN

Sc285

Probably just dirty id sensors

Line position adjustment (MUSIC) errorLine position adjustment fails four consecutive...

Hi guys looks for all service and parts manuals for Canon Ipf785 Plotter with m40 large format scanner fitted thank you in advance.

Don't know why you done the above its just damp they why it clears after drum refresh.
Maybe ask customer to have oil heater on low at night

+1 same here

Check the fuser also isn't there a guide on the door that sticks

I find these machines very reliable the bk oem pcu is 60k pm life they always go way over what's the other parts life have you any samples

So did you just replace the drum cylinder or a new oem pcu

Hope this helps

Try new bottle make sure sensors are clean also check the drive gear that drives it I've had a couple of them break

Could be the white plate on the under side of the document feeder unit also make sure the feeder is square on machine

What's pm lifes

Its most probably the pressure roller end thermistor quite common also don't just replace sleeve on its own always replace new oem sleeve assy.
I always replace sleeve assy, pressure roller,...

The pumps from a mpc3300 are not the same. This problem is usually caused by cheap toner cartridges with rubbish chips