Search:

Type: Posts; User: blackcat4866

Page 1 of 20 1 2 3 4

Search: Search took 1.34 seconds.

  1. Re: Ipf 770 with L36 has lines when printing

    Sorry, I can't get anything from your attachments. Can you try another way? =^..^=
  2. Replies
    7
    Views
    230

    Re: BH C654e FW

    The C654e and C754e use the same firmware. You've got something else going on there. =^..^=
  3. Replies
    26
    Views
    646

    Re: [PICS] What needs replacing here?

    I was wondering about the circle pattern.

    Yes all the drums are bad. I never saw the point in re-chipping old drums. Start there, and the gradation and stabilization. Use good quality 96...
  4. Replies
    26
    Views
    646

    Re: [PICS] What needs replacing here?

    Before you spend a lot of money try this:
    Wand the primary charge wires and laser slit glasses, then print off these images and post the results.

    130K is not really a lot on the developing units....
  5. Replies
    4
    Views
    160

    Re: e-studio 307 hard drive install

    The first few times I was a nervous wreck. 'Why is it taking so long!!". =^..^=
  6. Replies
    4
    Views
    160

    Re: e-studio 307 hard drive install

    It usually takes 14minutes minimum to as much as 27minutes to enter 08 mode after a firmware update. Did you wait that long? Otherwise it sounds like you did everything else correctly.

    So I don't...
  7. Replies
    8
    Views
    397

    Re: Counter of each paper cassette

    It sounds like a person with some basic third grade math skills should be able to subtract the previous total from the final total, to get a specific count. That can be done based on total count, or...
  8. Re: Black Copy with Lexmark MX 511 after performing Scanner Calibration Reset

    Did you notice that the manual tells you not to Reset values unless scanner has been replaced? =^..^=
  9. Replies
    8
    Views
    518

    Re: Request sample test chart

    How about this?
  10. Replies
    8
    Views
    518

    Re: Request sample test chart

    A5, A4, A3 sizes? Something else?
    =^..^=
  11. Replies
    8
    Views
    397

    Re: Counter of each paper cassette

    Most Konica Minolta devices count feeds in service mode > Life > Counters > then select whatever you want to check or reset. (Note: not lifetime, resettable counters). I could be more specific if I...
  12. Re: bizhub C227 clacking noises when Paper feed from tray 2.

    5) You are the person onsite. Only you can make observations.

    =^..^=
  13. Re: bizhub C227 clacking noises when Paper feed from tray 2.

    What error? All you said was noise. =^..^=
  14. Replies
    10
    Views
    353

    Re: Kyocera Ecosys P2135dn Fuser dirty

    +1

    I recommend this to every user and set personal machines to 2 minutes maximum time to low power. It will triple the life of the fuser. If Silent Mode is available even better. =^..^=
  15. Replies
    11
    Views
    205

    Re: Konica c352 fax issue

    How about turning down or turning off the monitor. There's no reason that the volume has to be up. =^..^=
  16. Replies
    9
    Views
    163

    Re: new guy - hello

    Welcome! =^..^=
  17. Re: bizhub 350 with df-605 "jamming" but you open the cover and close it and jam clea

    Usually when all the originals feed, then shows a jam after the last page has cleared, it's usually a problem with the original detection sensor or flag. I haven't looked at a 350 in ages, but it's...
  18. Replies
    3
    Views
    174

    Re: Bizhub 654e Tray 1 not closing

    Funny!

    At the high school, some of the kids discovered the latching mechanism toward the tray front. If you operate the grip of the tray you'll see latches retract on each side of the tray ... or...
  19. Replies
    8
    Views
    169

    Re: Screwdriver Ninja checking in

    Welcome! =^..^=
  20. Re: split vertical / horizontal lines on prints and copy documents.

    The lines of shame are usually cyan or magenta, AFAIK never black. =^..^=
  21. Replies
    4
    Views
    269

    Re: invalid black

    I've read other posts here implying that Xerox can code toner cartridges to a specific machine, and will work in no other machine.

    It sounds like something Xerox would do. =^..^=
  22. Replies
    3
    Views
    219

    Re: Sharp MX-B355 Registration timing

    What you've just described can be either:

    registration clutch
    seizing registration bushings
    late paper feed from the paper tray

    =^..^=
  23. Replies
    10
    Views
    353

    Re: Kyocera Ecosys P2135dn Fuser dirty

    I don't spend much time scrubbing fuser rollers these days, but when I did I'd drip some fuser oil (6 to 10 drops) onto the heat roller and warm it up several times. This softens up toner buildup on...
  24. Re: split vertical / horizontal lines on prints and copy documents.

    Maybe a dusty polygon mirror? =^..^=
  25. Replies
    6
    Views
    137

    Re: Hello everyone

    Welcome! =^..^=
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4