Search:

Type: Posts; User: 100spc

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    1,314

    The space between developing roller and drum was...

    The space between developing roller and drum was below lower limit specification. The centrifugal force causes the toner on the mag roller to be a larger diameter and creates toner build-up around...
  2. Replies
    1
    Views
    1,325

    [Misc] set the colour to what you want to be the new...

    set the colour to what you want to be the new default, then

    utility counter - user settings

    look for copy settings (could be initial settings, can't remember off the top of my head), then...
  3. Replies
    2
    Views
    955

    c450's have strong belts (imo), they tend to last...

    c450's have strong belts (imo), they tend to last a good couple of lifetimes provided they don't get any dents or scratches in the surface.

    print some A3 (or equivalent large sized) gradations...
  4. Replies
    1
    Views
    565

    CAUSE: Possible failed Scan board. SOLUTION:...

    CAUSE: Possible failed Scan board.
    SOLUTION: Remove the scan memory board. This board is mounted on the MFBS and is the closest board to the flash ROM socket. If the machine will
    come to ready when...
  5. Replies
    3
    Views
    1,024

    With a new machine comes different drivers and...

    With a new machine comes different drivers and settings, perhaps you have these set to high or higher quality than the last and as such is creating slightly bigger print jobs that take longer to...
  6. Replies
    5
    Views
    11,847

    You're right, the manuals do usually say to use...

    You're right, the manuals do usually say to use nothing on the glass and to also have the lights out for best results, but both ways seem to work fine.
  7. Replies
    6
    Views
    3,469

    It always pays to check the scan settings. A...

    It always pays to check the scan settings. A 200dpi grayscale scan will transmit faster than a 600dpi colour image.
  8. Replies
    5
    Views
    11,847

    CAUSE: Original Size Detection Adjustment has not been performed.

    Perform the Original Size Detection Adjustment:
    Place A3 paper on the Glass
    1. Enter Service Mode.
    2. Select 'Machine'.
    3. Select 'Original Size Detection Adjustment' and press the...
Results 1 to 8 of 8