Search:

Type: Posts; User: spanky

Page 1 of 14 1 2 3 4

Search: Search took 0.29 seconds.

  1. Replies
    3
    Views
    137

    Re: MX-M5070N admin password reset? No DSK

    See attached
  2. Replies
    5
    Views
    143

    [Misc] Re: Confirmation report

    System settings/list print administrator/image sending activity report(fax)
  3. Replies
    8
    Views
    506

    Re: Sharp MX-4070 admin password

    You can buy the msata card already with the basic programming required from sharp. You don't have to buy an entire copier.

    Just copy the msata card you receive from Sharp for future use.
  4. Re: Sharp MX2651 Color - Tray-2 11 x 17 Print Issue

    The last two copier companies i have worked for had shop techs for setting up copiers.

    I assumed the same for your company.

    My mistake, you know what they say about assuming something, and I...
  5. Re: Sharp MX2651 Color - Tray-2 11 x 17 Print Issue

    If the sim had been run they would have noticed before delivery they had a problem, not in the customers office.
  6. Re: Sharp MX2651 Color - Tray-2 11 x 17 Print Issue

    how did the builders run sim 50-10 for image alignment?

    It is supposed to be run out of each tray.

    Sounds like your shop guys need more training.
  7. Re: 11x17 pdf documents not printing correctly on MX-5071

    If you look closely at the settings in the printer settings of the copier, you will see that the setting for the 11X17 paper is backwards.

    It sets the 11X17 to print on A3 paper.
  8. Replies
    17
    Views
    932

    Re: MX-3610 color and calibration problem.

    46-74 Will not complete and will tell you to place the original on the glass if the page you put on the glass does not have solids.
  9. Replies
    53
    Views
    5,198

    Re: The future of work

    Google cloud print will be discontinued at the end of this year.
  10. Replies
    14
    Views
    712

    Re: FN18 saddle stitch jamming

    I would try cloning the customers machine and then resetting it to factory settings.

    You can then push the cloned file back into the machine so you don't loose any settings.
  11. Replies
    6
    Views
    507

    Re: Sharp mx 3070 /doc feed issue

    Have you tried sim 53-7 to set the sensitivity of the width sensor?

    See page 6-93 in the service manual.
  12. Replies
    5
    Views
    270

    Re: Status Message by E-mail Request Setup

    You set the schedule you want and the email address to send the information to.

    The information it sends is the page counts, if you have a customer that is charged by the page count you can get...
  13. Replies
    14
    Views
    712

    Re: FN18 saddle stitch jamming

    This code says the paper is still at the last sensor in the paper pass unit.

    Check the level and height of the finisher.

    I have seen this happen when the finisher is not at the proper height or...
  14. Re: Sharp MX- 3100 prints and copies only Yellow

    Run shy shots for each color in the single color mode.

    Stop the machine during the cycle to see if there is toner on the drum.

    This will tell you if it could be the transfer belt.

    If toner...
  15. Replies
    13
    Views
    504

    Re: Sharp MX-5141N firmware update

    Yes, I was mistaken.

    You are in the right place.

    I would start a new thread asking for the files needed for the SD card
  16. Replies
    13
    Views
    504

    Re: Sharp MX-5141N firmware update

    Only place I know of is Sharp.

    You can ask in the firmware request area of copytechnet if anyone may have the files you need.

    I do not have them.
  17. Replies
    13
    Views
    504

    Re: Sharp MX-5141N firmware update

    Did you buy the SD card from Sharp?

    The SD card must have basic data on it when installed.

    If you put a blank SD card in the copier it will not work.
  18. Re: MXM5071 problems printing complete documents from remote workers

    You can turn off the WSD in the copier's printer port settings.

    If you do this windows will no longer load a WSD driver.
  19. Re: anyone here know how to make FAST ALCOHOL "not for drinking"??

    I was in my local Lowes hardware store yesterday and they had plenty of the alcohol used for stoves.

    It is potent enough to use as a cleaner and sanitizer.
  20. Replies
    11
    Views
    580

    Re: Multiple pages into individual

    The image I posted is a PDF

    Download the free Adobe PDF reader
  21. Replies
    11
    Views
    580

    Re: Multiple pages into individual

    The suggestion I submitted is adjusted by job, not a permanent setting.
  22. Replies
    11
    Views
    580

    Re: Multiple pages into individual

    See attached instrucitons
  23. Thread: Sharp easy mode

    by spanky
    Replies
    3
    Views
    400

    Re: Sharp easy mode

    To remove the easy settings from the top of the home screen you can also open the settings/common settings/operation settings/mode key display setting/ and at the bottom of the page uncheck the box...
  24. Replies
    15
    Views
    2,272

    Re: Several Sharp generations having email issues

    Unless the frontier is an MB401 there is firmware to upgrade the copier to use TLS1.2.
    This allows the use of 365.
  25. Replies
    10
    Views
    907

    [Misc] Re: MX-3570 Printing Bad Image

    LSU
Results 1 to 25 of 341
Page 1 of 14 1 2 3 4