Search:

We can supply the latest version should anyone need it.

Firmware Update - Printer & Copier Firmware

A squeak is genuinely noting to worry about, most of my 5 year old Bizhubs all squeak simply ignore it.

Sounds like you have walked into a s**t storm.

First check the machine if the machine has an HDD (simply remove the rear left cover) default HDD was 320Gb so simply replace if this is missing. The...

Replace a full set of PCU, only replace the dev units if the solids are poor, but personally I fit a new K dev with the drum.

Even if the transfer belt is over life no need to replace. I simply...

Did you fit a NEW black image unit or a used one? if not new replace it with a genuine KM drum & toner.

Update the firmware while you’re there.

TNR levels should be around 6.5% one of them may stand out being too low or high.

Set off a full colour print run or test patterns in service mode, the machine will show 'internal error' & will reboot 3 times.

Keep running a print run the machine will eventually stop & show the...

But DHCP would not pick a duplicate IP thats one of its main jobs.

Well done, thanks for the update.

Firmware Update - Printer & Copier Firmware

No, see attached.

47964

Trouble Reset.

47965

I've never used a MAC to create a FW USB, if you have access to a Windows PC you could also try that.

If your laptop connects fine then most likely the copier is OK.

Can you wheel the machine & swap it with another copier you say is working fine? This will confirm it's not the wall LAN socket or...

Here's a long shot, leave the firmware in the service slot.

Shut the machine down, must use the power switch inside the front door NOT the one on the control panel.

Hold down the...

Here is the service manual so have a read.

https://mega.nz/file/lQ0kWZTY#cCnN-5vwvK_HqtQW30TeJB6yW5BLafTWIu4DPiD8MgQ

Search for manual add toner. Now see my previous post, take off the inner...

Maybe Phil B should read the manual .......... :cool:

Had this same issue on an x02 series set trays to auto. Bit bizarre not yet resolved with a firmware fix.

Call Xerox support in your country.

2.5" SATA 320GB, however as you know you can pretty much use any size within reason.

Back in the day (late 80's early 90's) it was a suit & tie.

Now I simply wear smart shoes, suit trousers & plain shirt. (no tie)

However IT/Network support dress like a courier driver, usually...

As harsh as this reply is, this will be your best bet rather than wait for a reply, especially if you are in a different time zone.

He posted he is using the service USB slot & he has access to the service manual so I would assume so.

Or if you are an end user any colour fits in any hole apparently!

Bit late now to give advice ........... :cool:

I have always formatted my USB pen drives in Windows & never at an issue before. Others will tell you this is wrong & you should use a 3rd party format software tool.

In my experience try a few...