Search:

Type: Posts; User: copyman

Page 1 of 20 1 2 3 4

Search: Search took 1.25 seconds.

  1. Replies
    20
    Views
    751

    Re: Shady Konica Bizhub seller

    Why chip the units and reset the voltages, etc with an overlife drum? Just turn off the messages and run until a quality issue.
  2. Replies
    11
    Views
    191

    Re: Konica c352 fax issue

    Check and see if remote care is on. Not sure if you can block #'s on this old machine. Did you try calling or sending a fax to the # on fax log to see who it is?
  3. Replies
    5
    Views
    898

    Re: Who is investing in Bit Coins-

    Old news. The original post was 2018
  4. Replies
    20
    Views
    751

    Re: Shady Konica Bizhub seller

    If I was buying a machine for $600 and the seller told me it had new supplies I would run away. It's just common sense there would be no way someone could make money putting all new supplies and...
  5. Replies
    5
    Views
    177

    Re: Develop 284E Konica minolta C284

    Only takes 1 bad toner. As discussed on this forum many times it's just not worth using aftermarket toners. If it crashes a developer unit it can be expensive!

    If it wasn't aftermarket toner I...
  6. Replies
    3
    Views
    187

    Biz 364e security

    Anyone know if there is a security or some other setting that would prevent a user from registering email addresses? Their IT people setup SMB scanning and is working fine. Customer said they had...
  7. Replies
    20
    Views
    751

    Re: Shady Konica Bizhub seller

    I buy off lease machines all the time. I buy low meter machines and they are great! Make a lot of profit and customer saves a lot of money. Everyone happy.

    As for your problem I don't think you...
  8. Thread: Please Help

    by copyman
    Replies
    11
    Views
    270

    [Error Code] Re: Please Help

    Checked Kon/Min knowledge base and nothing on USA side for that code.

    This procedure is exclusive to reset fuser errors.

    To reset the code, perform the following:

    1. Power the machine OFF...
  9. Replies
    16
    Views
    373

    Re: Bizhub C364 Can no longer access

    when in service mode did you see if HDD was installed? System 2.
    Also take left rear cover off and see if HDD is there and connected
  10. Thread: Please Help

    by copyman
    Replies
    11
    Views
    270

    [Error Code] Re: Please Help

    Seems like you covered everything. Is there a separate pwr sup for the IH fuser or is that what you replaced?

    You even replaced the PRCB board that would trigger the fuser to turn on.

    Do you...
  11. Thread: Please Help

    by copyman
    Replies
    11
    Views
    270

    [Error Code] Re: Please Help

    Very interesting. Looked in the parts book and sure enough it shows the different fuser. Probably why that trouble code is different, only used in Japan.

    I never really had any problems with the...
  12. Thread: Please Help

    by copyman
    Replies
    11
    Views
    270

    [Error Code] Re: Please Help

    What have you done so far? Try and do a trouble reset at least? You can Google procedure to do trouble reset.

    The others are correct. I've rebuilt many of these fuser units and they use heat lamps...
  13. Replies
    16
    Views
    373

    Re: Bizhub C364 Can no longer access

    Have you had any lightning storms? Reason I asked is always have a few machines with this symptom during the summer months.

    You can initialize the machine in service mode and re-input settings.
    ...
  14. Replies
    1
    Views
    274

    Happy 4th to all !!!

    To all American patriots on this forum enjoy the holiday.

    And to all the misreable people that hate America move to another country if it's that bad!

    GOD bless America during these tough times.
  15. Replies
    6
    Views
    723

    Re: KM bizhub C3350 ADF problem

    Glad you got it fixed. That is one of the worse feeders. Seems Kon/Min can never design a good small machine as reliable as their bigger copiers. Almost like they don't care that much for the low end...
  16. Replies
    13
    Views
    401

    Re: Konika Minolta c454e color problem

    I agree except genuine color toners from a dealer (most people buy the toner from where they bought the machine) cost $92 for TN321 color and around $55 for black as one example. They can buy...
  17. Replies
    13
    Views
    401

    Re: Konika Minolta c454e color problem

    Glad to help. Good to hear it's working good now.

    Just curious did you replace the complete Dev units or just used aftermarket developer powder in each one?

    Using genuine consumables costs a...
  18. Replies
    13
    Views
    401

    Re: Konika Minolta c454e color problem

    Really hard to troubleshoot when using aftermarket toners. With 600k meter I would look at the Dev units at this point.

    As the other poster said you should only use genuine Kon/Min with color...
  19. Replies
    22
    Views
    682

    Re: Konica Minolta c554e Print quality issues

    I've had your exact issue at least 20 times, I call it the dev white lines of death. Never once has it been a high voltage issue. It has always been an overlife drum of same color as bad dev unit or...
  20. Replies
    22
    Views
    682

    Re: Konica Minolta c554e Print quality issues

    I use to ask for someone to make a donation to this website before sending a manual but since there is no moderation on this forum I stopped doing that. PM me and will send it to you. If you want to...
  21. Replies
    22
    Views
    682

    Re: Konica Minolta c554e Print quality issues

    Do you have the service manual showing where parts are? Many here including myself don't mind helping "novices" or "end users" to a certain point but when the poster asks where things are located not...
  22. Replies
    11
    Views
    373

    Re: Clean the ph unit without taking it apart

    And sometimes "doing it the right way" and taking a machine apart that was put together by robots can cause an issue that you didn't have before taking apart.
    Just my way of doing things but I will...
  23. Replies
    5
    Views
    647

    Re: Married... with Children

    Agree, sometimes a comedy series has a cast that just fit together, and this was one of them. Not to mention how HOT Christine Applegate was on that show!
  24. Replies
    22
    Views
    682

    Re: Konica Minolta c554e Print quality issues

    One of the developers dumped. Take the drums out and look at dev units and you will see one or more of them has little developer on mag roller. Most likely black. Search this forum about "4" series...
  25. Thread: -70 point rep?

    by copyman
    Replies
    5
    Views
    184

    Re: -70 point rep?

    LOL. Thanks for the rep point fatduke. Right after I posted someone took a point from me. Morons keep wasting their time. Fools. Hide behind a keyboard and take a point from someone, oh wow what a...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4